Crosley Lydia CF7004 User manual

Left Side Panel FrontTopRail FixedShelf
BackBottomRail
BackTopRail
BackPanel
Right Side Panel BottomPanel TopPanel
SupportPlate
RightDoor
Left Door
DrawerFrontPanel DrawerSidePanel DrawerBottomPanel
DrawerBackPanel

FX1
GX1
CamLock 15*12mm
Magnet L70*H12mm
Round Head Bolt
5/32"*19mm
CamBolt 6*42mm Wood Dowel8*30mm
Knob 29*27mm
Short Screw3.5*25mm
Long Screw4*57mm
DrawerStopper29*27mm Screw3*12mm Wall Anchor8*38mm
PhillipsHeadScrewDriver
Note:Itisnotrecommendedtouse powertoolsduring assembly. You may use power
toolstoassistinmounting thesafetystrapkittothewall.
Screw3*15mm

AttachKnob (D)toDoors(10 &11)using Round Head Bolt (E).
AttachMagnet(H)exactlyasshown.
FixCamBolt (B)toSide Panels(1&7),BottomPanel (8)and Top Panel (9),asshown .
AttachDrawerStopper(J) exactlyasshown.
AttachDrawerStopper(J) exactlyasshown
AttachMagnet(H)exactlyasshown

Set DrawerFront Panel (13), DrawerSide Panels(14), DrawerBottomPanel (15)and Drawer
Back Panel (16)intoplaceusing Short Screw (G).
AttachKnob(D)toDrawerFront Panel (13)using Round Head Bolt (E).
AttachRail (2&5&6)and shelf (3)toRightSide Panel (7)using Wood Dowel (C)and
CamLock(A) .
Set Left Side Panel (1)intoplaceusingWood Dowel (C)and CamLock (A).

PlaceTop Panel (9)tothe ground and insert Back Panel (4)intocabinet .
Set Top Panel (9)intoplaceusing CamLock (A).
Note:InsertBack Panelexactlyas shown.
9

Set Doors(10 &11)intoplace.
Set BottomPanel (8)intoplaceusing CamLock (A).

Hold the Support Plate(12)in the desired location of the wall unit. Thisplatewill be about 2-1/2”
lowerthan the top of the wall unit. Making surethe Support Plate(12)islevel, useapencil to
markthe anchorlocationsusing the Support Plate(12)screw holesasaguide. Werecommend
using alevelertomakesurethe SupportPlate(12)isoriented correctly.
-Drill two 11/32”holesin thesemarked spotsand tap the Wall Anchors(L)intothe drilled holes.
Securethe Support Plate(12)tothe Wall Anchors(L)withScrews(F). See Image.
-Mount the completed unit ontothe Support Plate(12). The back of the unit hasarecessed
area that will hookon tothe Support Plate(12). Useapencil tomarkthe 2nd set of anchor
locationsusing the holesin the wall unit asaguide. See Image.
-Removethe wall unit and drill two 11/32”holesatthe pencil marks, and tap the Wall Anchors
(L)intothe holes.
-Remount the wall unit and secureit tothe WallAnchors(L)withScrews(F). See image.

Insert drawerintocabinet .