Crosley Sedona CO600142-BK User manual


HARDWARE LIST
6
78
9
PARTS LIST
Cylinder Bolt
(M8*25)
4 PCS
Leg
4 PCS
Top
1 PC
Stretcher
1 PC
Bolt
(M6*30)
8 PCS
Flat washer
(M6)
8 PCS
Bolt cap
(M6)
8 PCS
Wrench
(M6)
1 PC
(M8) (M8) (M8) (M8)
4444
PCS PCS PCS PCS

3
67(3 
Figure 1
Place Top (A)
upside down on a soft cloth.
Insert all Cylinder Bolts (Part #1) into
.
%
%
%
%
&
$
Nut Cap
(M8)
(M8)
(M8)
(M8)
Nut
Spring Washer
Flat Washer
(M6)
Flat Washer
Bolt(M8*25)
Bolt
(M6*30)
Bolt Cap
(M6)
)LJXUH
Flathead screw
driver(not included)
Figure 2
8
6
7
5
4
2
3
1
Step 1:
Step 2: Attach two adjacent Legs (B)
to Top (A) by inserting the Cylinder
Bolts (Part #1)
the ends of the Legs (B). Now secure
through the holes in
the Legs (B) using Flat Washers
(Part #3),Spring Washers (Part #2)
& Nuts (Part #4).
Note - -Tighten Nuts only half way
using wrench (#9) .
Step 3: Attach Stretcher (C) to
attached Legs (B) using Flat Washers
(Part #7),and Bolts (Part #6) as shown.
Note - Tighten Nuts only half way with
wrench (#9).Now attach the other two
Legs (B) to Top (A) & Stretcher (C)
using the same method as the first
two legs.Tighten all bolts completely
with wrench (#9).
Step 4: Cover all Nuts and bolts with
Nut Caps (Part #5) & Bolt Caps (Part
#8).Turn the table over into the upright
position in your congratulations! You
are finished.
fTthe pre-drilled holes o op (A).
Flat Washer (M8)
Nut (M8)
3
4
Nut Cap (M8)
5
Spring Washer (M8)
2
Bolt (M8*25) x 4
x 4
x 4
x 4
x 4
1
Bolt (M6*30)
6x 8
Flast Washer (M6) x 8
7
Bolt Cap (M6) x 8
8