MAINTENANCE
The charger is maintenance free. Note that disassembly of the charger is not permitted and
will void the warranty. If the power cord is damaged, the charger must be left to the reseller for
maintenance. The case can be cleaned with a soft damp cloth and mild cleanser. The charger
should be disconnected from the power while cleaning.
WARRANTY
CTEK SWEDEN AB, Rostugnsvägen 3, SE-776 70 VIKMANSHYTTAN, SWEDEN provides a
limited warranty to the original purchaser of this product. This limited warranty is not transfer-
able. The unit is warranted against defective workmanship or materials for 3 years from the
date of purchase. The customer must return the product together with the original purchase
receipt to the place of purchase. This warranty is void if the unit is handled carelessly, opened
or repaired by anyone other than CTEK SWEDEN AB or its authorized representative. CTEK
SWEDEN AB makes no warranty other than this limited warranty and expressly excludes any
implied warranty including any warranty for consequential damages. This is the only expressed
limited warranty and CTEK SWEDEN AB neither assumes nor authorizes anyone to assume or
make any other obligation towards the product other than his limited warranty.
TECHNICAL SPECIFICATION
Model 1007
Voltage AC 170–260VAC, 50–60Hz
Back current drain* < 1mA
Charging voltage 14.4V (Nominal 12V)
Ripple** Max 150mV rms, max 0.3A (=4%)
Current 7A max
Ambient Temperature -20°C – +50°C, power is reduced automatically at
increased ambient temperature.
Cooling Natural convection.
Charging cycle ONYX is a multi stage fully automatic charger
Type of batteries All types of 12V lead-acid batteries (Wet, MF, AGM and GEL).
Battery Capacity 14–225Ah
Dimensions 191 x 89 x 48 mm (L x W x H)
Insulation IP65
Weight 0.8 kg
*) Back current drain is the current that the charger drains the battery with, if the wall socket
is disconnected.
**) Quality of the current and voltage are very important. High current ripple heats up the
battery and makes the positive electrode age prematurely. High voltage ripple could harm other
equipment connected to the battery. ONYX produces a high quality current and voltage with
very low ripple.
MANUFACTURERS DECLARATION
CTEK SWEDEN AB, Rostugnsvägen 3, SE-776 70 VIKMANSHYTTAN, SWEDEN. Declares
under sole responsibility that the battery charger ONYX, to which this declaration relates is
in conformity with the following LVD standards: EN60335-1, EN60335-2-29 according to the
terms of directive 73/23/EEC with the addition of 93/68/EEC. This product also is in agreement
with the following EMC standards: EN55011, EN61000-3-3, EN61000-3-2, EN55014-1 and
