DÖRR S-LIGHT User manual

doerr-outdoor.de
S-LIGHT
LED SENSOR HEADLIGHT
INSTRUCTION MANUALGB
IPX4
500 mAh
3,7 V
SENSOR 160
LUMEN
max.

doerr-outdoor.de2
01 | SAFETY HINTS
• This device is not a toy! To prevent accidents and suffocation
keep the device, the accessories and the packing materials away
from children and pets.
• Do not look directly into the LED and do not direct the light
beam into the eyes of humans or animals.
• Do not point the light at vehicles or aircrafts.
• People with physical or cognitive disabilities should use the device
with supervision.
• People with cardiac pacemakers, defibrillators or any other elect-
rical implants should maintain a minimum distance of 30 cm, as
the device generates magnetic fields.
• Do not submerge or throw the device into water. Do not throw the
device into fire – risk of explosion!
• Protect the device from rain, moisture, direct sunlight and extreme
temperatures.
• Do not operate or touch the device with wet hands.
• Never leave the device unattended while charging the battery. After
charging, disconnect the device from USB power supply.
• If the device is not used for a longer period of time, charge the
battery to approx. 60% to avoid deep discharge of the battery.
• Protect the device against impacts. Do not use the device if it has
been dropped. In this case a qualified electrician should inspect the
device before you use it again.
• Do not attempt to repair the device by yourself. Risk of electric
shock! When service or repair is required, contact qualified service
personnel.
• The built-in battery and the LEDs cannot be replaced.
• Protect the device against dirt. Never use aggressive cleansing
agents or benzine to clean the device. We recommend a soft,
slightly damp microfiber cloth to clean the outer parts of the device.
Before cleaning, turn off the device and disconnect from the
power source.
• Store the device in a dust-free, dry and cool place.
• If the device is defective or without any further use, dispose of the
device according to the Waste Electrical and Electronic Equipment
Directive WEEE. For further information, please contact your local
authorities.
GB
THANK YOU very much for choosing a quality product by DÖRR.
Please read the instruction manual and the safety hints carefully
before using the device for the first time.
Keep the operating instructions together with the device for referen-
ce. If other people use this device, provide them with these instruc-
tions. If you sell the unit, this manual forms an integral part of the
device and must be supplied with it.
DÖRR is not liable for damage caused by improper use or failure to
observe the operating and safety instructions.
In the event of damage caused by improper handling or by external
influence, the guarantee or warranty claim becomes void. Any ma-
nipulation, structural modification of the product or opening of the
housing by the user or an unauthorised third party shall be considered
improper handling.

doerr-outdoor.de3
02 |PRODUCT DESCRIPTION
Ultra slim and lightweight LED headlamp with sensor function.
The DÖRR S-Light headlamp is a reliable LED light source for cycling,
jogging, hiking and other outdoor activities. Depending on your
needs, you can choose between different lighting functions and
brightness levels. With the practical sensor function, you can switch
the lamp on or off with just a wave of your hand and always have both
hands free.
• Ultra bright, white 3W XPG LED + 2x COB LEDs
• Very slim housing with rubber coating made of non-slip, soft
silicone
• Quick and easy adjustment to head or helmet size
• Built-in, long-lasting lithium polymer battery 3.7V, 500mAh
• Including USB-C charging cable
03 |NOMENCLATURE
01 On/O button
02 Sensor button
03 Blue LED indicator sensor function
04 Auxiliary lights COB LED
05 Sensor
06 Main light 3W XPG LED
07 USB-C charging socket with LED indicator
07a) Rubber cover
08 USB-C charging cable
09 Fixation headband
04 |ILLUSTRATION OF PARTS
07
07a
08
09
04 04
05 06
01 02
03
01 02
03

doerr-outdoor.de4
05 |FIRST STEPS
05.1 Charging the integrated battery
▶ NOTICE
Please fully charge the built-in lithium polymer battery before first
use.
Open the rubber cover (07a). Below is the USB-C charging socket
(07). Connect the headlamp to a USB charging source, e.g. PC/laptop/
power bank, using the supplied USB-C charging cable (08).
During the charging process, the USB-C charging socket (07) lights up
red. After approx. 2 hours the battery is fully charged and the USB-C
charging socket (07) lights up green. Disconnect the headlamp from
the USB charging source before turning on the lamp. Close the
rubber cover (07a) again properly to ensure splash protection.
CAUTION
• Never leave the device unattended while charging the battery.
After charging, disconnect the device from USB power supply.
• If the device is not used for a longer period of time, charge the
battery to approx. 60% to avoid deep discharge of the battery.
05.2 Adjusting the Headband
To adjust the headband to your head or helmet, carefully push the
headband out of the fixation (09). Adjust the required length and press
the headband back into the fixation (09).
06 |HEADLIGHT FUNCTIONS
Press On/O button (01)
once
Main light (06) lights up.
100% brightness.
Press On/O button (01)
a 2nd time
Only the two auxiliary lights (04) light
up.
100% brightness.
Press On/O button (01)
a 3rd time
Main light (06) and both auxiliary
lights (04) light up.
100% brightness.
Press On/O button (01)
a 4th time
Main light (06) and both auxiliary
lights (04) light up.
50% brightness.
Press On/O button (01)
a 5th time
Main light (06) and the two auxiliary
lights (04) flash (strobe).
Sensor function
In any lighting mode, press the sen-
sor button (02) to activate the sensor
mode. The blue LED indicator (03)
lights up.
Now the headlight can be switched on
and o with just a wave of the hand in
front of the sensor (05). Press the sen-
sor button (02) again to exit the sensor
mode (blue LED indicator (03) o).
When the lamp is switched o, you
can directly activate the sensor mode
by pressing the sensor button (02). To
switch to normal lighting mode, press
the sensor button (02) again.
Turn o the
headlamp
In any lighting mode, press the On/
O button (01) for about 2 seconds to
turn o the headlamp.
▶ NOTICE
If the headlamp is in sensor mode and the light is o, the headlamp
is still under voltage and consumes energy. Therefore, do not for-
get to switch o the headlamp after use with the On/O button
(01) (blue LED indicator sensor function (03) = o).

doerr-outdoor.de5
07 |CLEANING AND STORAGE
Never use aggressive cleansing agents or benzine to clean the device.
We recommend a soft, slightly damp microfiber cloth to clean the
outer parts of the device. Before cleaning, switch o the device and
disconnect from power supply. Store the device in a dust-free, dry and
cool place. This device is not a toy - keep it out of reach of children.
Keep away from pets.
08 |TECHNICAL SPECIFICATIONS
LEDs 1x 3W XPG LED + 2x COB LEDs
Brightness approx. 160 lumens
Range max. 50 m
Internal battery Lithium Polymer 3.7V, 500mAh
Charging time approx. 2 hours
Operating time approx. 2,5 hours
(with fully charged battery)
Protection class IPX4
Housing Silicone, ABS, PC
Colour black
Dimensions approx. 27,5 x 12,5 x 2,2 cm
Weight approx. 62 g
DÖRR GmbH reserves the right to make technical changes without notice.
09 |SCOPE OF DELIVERY
1x LED Sensor Headlight S-Light
1x USB-C charging cable
1x Safety hints
10 |DISPOSAL, CE MARKING
10.1 DISPOSAL OF BATTERY/ACCUMULATOR
Batteries and rechargeable batteries are marked with the symbol of a
crossed-out waste bin. This symbol indicates that empty batteries or
rechargeable batteries that can no longer be recharged must not be
disposed of in household waste. Old batteries may contain harmful
substances that can cause damage to health and the environment. As
the end user, you are legally obliged to return used batteries (under
German battery law, Section 11 Act Revising the Law of Waste-Rela-
ted Product Responsibility for Batteries and Accumulators). You can
return batteries free of charge after use at the point of sale or in your
immediate vicinity (e.g. at municipal collection points or in shops). You
can also return batteries to the seller by post.
10.2 WEEE INFORMATION
The WEEE (Waste Electrical and Electronic Equipment) Directive,
which came into force as European law on 13 February 2003, led to
comprehensive changes in the disposal of discarded electrical equip-
ment. The primary purpose of this directive is to prevent e-waste
while promoting reuse, recycling and other forms of reprocessing in
order to reduce waste. The WEEE logo (dustbin) shown on the product
and on the packaging indicates that the product must not be dispo-
sed of in normal household waste. You are responsible for deliver-
ing all discarded electrical and electronic equipment to appropriate
collection points. Sorting waste for separate collection and sensible
recycling of packaging waste helps to use natural resources more spa-
ringly. Furthermore, e-waste recycling is a contribution to preserving
our environment and thus also people‘s health. Further information
on the disposal of electrical and electronic equipment, recycling and
collection points can be obtained from local authorities, waste dispo-
sal companies, specialist retailers and the manufacturer of the device.
10.3 CONFORMITY WITH ROHS
This product complies with the European RoHS Directive on the res-
triction of the use of certain hazardous substances in electrical and
electronic equipment and variations thereof.
10.4 CE MARK
The imprinted CE mark complies with the applicable EU standards and
indicates that the device meets the requirements of all EU directives
applicable to this product.

doerr-outdoor.de6
DÖRR LED Sensor Headlight S-Light
Item-No. 980532
Made in China
DÖRR GmbH
Messerschmittstr. 1
D-89231 Neu-Ulm
Fon: [phone]
[e-mail]
https://www.doerr-outdoor.de