Da-Lite advantage User manual

DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: [phone]
800-622-3737
Fax: [phone]
www.da-lite.com
e-mail: [email protected]
POWER
PRESENTATION PRODUCTS
The
In
Instruction Book for
ADVANTAGE MANUAL WITH CSR
(Controlled Screen Return)

1. Remove access door. First remove the 2 screws from the ends (Fig.1). Be sure to support the door during this step
to avoid injury. Lift the door slightly and pull away from the edge of the case.
2. Carefully unpack screen and roller assembly. Leave packing paper on roller.
3. The roller mounting brackets are adjustable to allow for centering or offsetting the screen within the case. Loosen
the 4 setscrews on each bracket and slide the brackets towards the ends of the case.
4. Insert one end of the roller into the mounting bracket. The mounting brackets have a foam pad that the slat bar will
rest against. Be sure to install the roller assembly so the slat bar is positioned below these pads (Fig. 2).
5. Slide the other mounting bracket onto the roller pin. At this time you may need to center the roller assembly within
the case. You may need two people to slide the mounting brackets while holding the roller assembly. Tighten all 8
setscrews securely.
6. Re-install the access door. Procedure is reverse of removal.
1. Hang case and attach to support structure with bolts. See suggested methods of installation on page 2.
NOTE: Carriage bolts can be installed anywhere along the length of the case. The head of the carriage bolt slides into the
variable-position mounting channel. It is recommended that the center is supported on cases longer than 7 feet.
2. Tighten bolts until trim flange is flush with ceiling.
NOTE: For proper operation, screen assembly must be level after installation.
PRE-INSTALLATION
1
1. Carefully unpack case from shipping carton. DO NOT unpack fabric and roller assembly yet.
2. Make sure to recheck measurement of case for proper installation clearance.
3. Remove any protective foam or tape from case.
SCREEN AND ROLLER ASSEMBLY INSTALLATION
OPERATING SCREEN
1. Pull down on pull bail until desired picture area is obtained. Lock into position as on a window shade. Be sure
surface is locked before releasing.
NOTE: this screen will not lock into position in the upper portion of its travel.
2. To re-roll the screen, pull the picture surface down about 6 inches and start the fabric up quickly and release.
Large picture surfaces are heavy and will start up too slowly to prevent the locking pawl from catching unless help is
provided. If the locking pawl catches pull the picture surface down and start the surface up rapidly.
The CSR feature of this screen will allow the fabric to retract rapidly until about the last 6-12 inches of travel then it will
slow and retract gently into the case.
CASE INSTALLATION

2
FIGURE 1
REMOVE 2
SCREWS TO
REMOVE
ACCESS DOOR
FOAM PAD
MOUNTING BRACKET
SLAT BAR
FIGURE 2
ADVANTAGE MANUAL INSTALLATION
VARIABLE
POSITION
MOUNTING
CHANNEL
9-1/4"
3/8" THREADED
ROD (NOT
INCLUDED)
ATTACHED TO
HANGER
BRACKET
FINISHED
CEILING
SELF-TRIMMING
FLANGE
6-3/8"
7-3/4"
6-1/16"

Printed in U.S.A. 85778 Rev. 12/04
3