Dancover SEMI PRO 7x7m User manual

PARTY TENT SEMI PRO
7x7 - 2,3M
06-02-2015-SH

7x7m-2.3 PARTY TENT SEMI PRO
1. 8PCS 2. 27PCS 3. 16PCS 4. 8PCS 5. 4PCS 7. 4PCS 8. 2PCS
9. 2PCS 10. 4PCS 11. 4PCS 12. 4PCS 13. 2PCS 14. 2PCS 15. 4PCS
scp4scp6SCP48.1SCP47.1cp46.1 19.super peg 20.spiral peg
21.middle peg 22.small peg 24.Spanner 25.Screw 26.Wing nut 27. Screw
29. Screw 30.Nut 33.Rope 34.Roof
35.Sidewall
31. Long
bungeeball
8 pcs 36 PCS 2PCS 16PCS 16pcs 54pcs
4 8pcs 102pcs 132PCS 4PCS 1 pcs
6PCS
06-02-2015-SH
37.Endwall
3 Large door Small door 6. Endwall 1PC 1PC
2188mm Ø50mm 2210mm Ø38mm 1700mm Ø50mm 1750mm 640mm
M6x25mm M8x50mm
M8x60mm
M6
110o
110o90o90o
140o
140o

I
7x7m-2.3 PARTY TENT SEMI PRO
7
9 9
10
11
11
11
11
12 12
12 12
7
10
7
8 8
10
7
10
Select a at surface for the tent. Unpack the boxes and check if all listed parts are included. Assemble the roof frame by
mounting parts 7-12 on the pipes (Parts 2 and 3). Use the screws to rmly attach the parts.

7x7m-2.3 PARTY TENT SEMI PRO
III
IV
Attach the legs on the other side and
install the feet(13-16) at the bottom. Use
the long ground pegs to fasten the feet
to the ground. Reinforce the side frame
by attaching the turnbuckle set (18) as
shown on the drawing to the right.
Complete the bottom frame with the
required pipes(2) and connectors
(13-16).
Lift one side of the tent frame and
attach the legs(1). Place the roof onto
the frame and use the bungees to fasten
it. Be sure not to put too much tension
on the bungees in order not to make
attaching the other side more dicult.

7x7m-2.3 PARTY TENT SEMI PRO
V
Attach the sidewalls to the frame using
the bungees.
Attach the endwall directly to the roof
with velcro.
Connect the leg covers to the sidewalls
and endwalls with velcro as shown.
Use the short ground pegs to fasten the
endwalls to the ground.
The guy rope runs from every corner of
the tent and is braced to the ground
using the spiral pegs.
The super pegs provide the tent with
additional tension and stability.
Velcro
Spiral peg
Velcro