Dension GWL-9210-1 User manual

Gateway Lite MOST
For non text capable cars
Installation Guide
V1.2
GWL-9210-1
Gateway Lite emulates a CD changer and uses
CD changer controls to access offboard audio
sources like iPod and USB devices. If your car is
not already equipped with a CD changer, it may
be necessary to have the car programmed by your
dealer in order to use the GWL, according to the
followings:
BMW non iDrive-4
If original CD changer fitted no programming is
required.
If original CD changer not fitted install GWL and
retrofit “IPOD” option with service computer. In
case of E65 (before 03/2005) retrofit CDC
option.
Mercedes
Generally no programming is required but in some
cases (e.g. no device was connected onto the
optical ring) it is needed to enable a CD changer
with the service computer.
Porsche
Generally it is needed to enable a CD changer
with the service computer.
Saab 9-3
It is needed to enable a CD changer with the
service computer using an original CD changer.
(the CD changer is only necessary during the
installation process)
2 Connections 1 Programming the car for
GWL

Type A
If you are connecting Gateway Lite to the back
of the head unit, use this method:
Please note: CD changer retention is not
supported, therefore you need to disconnect it
from the optical ring if present and loop the
optical ring with the separate loop kit.
(FOA1TL1).
Type B
If you are installing the Gateway Lite to the
connector of the CD changer or to a free fibre
optic connector in the car (CDC preparation) use
this method:
Before connecting the Gateway Lite MOST
(GWL) device to the MOST ring, it requires a car
configuration procedure. The default car setting of
the GWL is Mercedes. Depending on the car type
it requires a different car configuration file.
Car configuration procedure of the Gateway
Lite MOST:
1. Copy the appropriate GW_CFG.BIN file to the
root of a USB flash drive
2. Connect the flash drive to the GWL MOST
when it is not powered
3. Please connect the power cable to the GWL
MOST
4. The GWL will start booting. In the meantime
the configuration procedure will start
automatically. Wait about 1 minute
5. Connect the GWL to the MOST ring
6. Turn the ignition & Head Unit ON and test the
GWL functionalities
7. Finish the installation of the Gateway Lite
MOST
The car configuration files can be downloaded
from the download section (Configuration files) of
the Dension website: www.dension.com
Test the Gateway Lite with your car audio, making
sure all connections are correct and that you have
full functionality.
Note: If during testing you notice any changes
or inconsistencies in the way the car’s
electrical system operates, disconnect the
Gateway product immediately and consult your
dealer.
Take care not to trap any wires and cables or the
Dension product. Refit is the reversal of the
removal process for your specific vehicle, as per
your manufacturer’s instructions.
All photos/illustrations are for representation
purposes only and may differ visually from the
equipment in your vehicle. Information correct at
time of going to print E. & O. E. Dension Audio
Sytems Ltd. and it’s registered partners cannot be
held liable for any damages caused by the
incorrect installation of any Dension product.
Need more help?
Please visit: www.dension.com/support
3 Installation33 Car configuration4 5
Test and refit