Digicom SNT06/1 User manual

I
S
D
N
T
.
A
.
SNT06-1 17/02/97
THIS DOCUMENT IS SUBEJCT
TO CHANGE WITHOUT NOTICE
digicom S.p.A.
-ITALY- 21010 Cardano al Campo VA via Alessandro Volta 39
Tel. [phone] - Fax [phone] - http://www.digicom.it
Data Communication
SNT06/1
Isdn modem
digicoms SNT06/1, pure ISDN modem, offers the connectivity
on ISDN network in order to transmit data from any data
processor or personal computer with serial interface in
synchronous or asynchronous mode. It seems a modem with
one serial port in V24/V28 and V35; the same design and the
same features are available in PC card version SNT13 and in
a PCMCIA standard format called CCI05.
By using together SNT06 and CCI05 or any other digicoms ISDN
product it is possible to exploit V120 protocol which,together
with V42bis data compression, allows to increase the
performances of a single communication channel B up to
speeds of 115,2 Kbit per second (about 11500 ASCII characters
transmitted in one second). In fact not evereybody knows that
with V110 protocol (which is implemented too) it is possible to
communicate in asynchronous mode on ISDN up to a speed of
38400 bps. This is limitative if compared to the real ISDN
potentiality which is used at 64 Kbit and whose cost does not
depend on speed.
In case of your access server is PPP/SLIP based, you can use the
integrated PPP support on SNT06; this is normally used in
Internet/Intranet or private IP network with Cisco or
compatible router and SNT06, like all digicom ISDN
products, is ready to communicate in this environment.
SNT06 is used as a modem, it supportsAT command, it is easy
to install and it doesnt need any particular software on ISDN
network. SNT06 has an internal telephone book and it manages
security procedures with caller indentification through support
to Call ID functions which are offered by ISDN network.
TECHNICAL FEATURES
lEuro ISDN compatible: NET 3 BRI.
lPPP internal support
lRate Adaption: V110, V120.
lV.42bis data compression.
lAT and V25bis commands in synchronous mode HDLC and
asynchronous.
lAutospeed up to 115.2 Kbit/s.
lSynchronous working up to 64 Kbit per channel.
lAsynchronous working up to 115.2 Kbit per channel.
l20 numbers phone book usable in AT compatible and V25bis
mode.
lSecurity function with caller identification (Caller ID support).
lCompatible with most popular communication programs.
lUsed as an Hayes compatible modem.
lMultinumber ISDN network service.
lSub-addressing ISDN network service (SUB).
lCaller identity ISDN network service (CLIP).
lLine interface on RJ45 connector for S/T bus.
lV24/V28 and V35 serial interface.
l220 V power supply 50Hz.
lConsumption: 10W.
lTemperature: from -5 to 45°C.
lMaximum humidity 90% non condensing.
lStandalone version dimensions: 190 x 147 x 45 mm.
lRackmount version dimensions: for 4 units rack high
and 19" width.
lStandalone version weight: 150 gr.
PRODOTTO CODICE DESCRIZIONE
SNT06/1 8D5372 ISDN modem V24/V35 PPP/V110/
V120/V42bis
S
U
P
P
O
R
T
PPP
I
N
T
E
R
N
E
T