Displays2go SCTWRCOLBK User manual

SCTWRCOLBK Assembly Instructions
Begin by laying out all your pieces for
easy access.
Remove floor levelers from all
panels. Lay out the front panel and
slide on both side panels, one at a
time.
Use included screwdriver to tighten
set screws.
Slide the door panel atop the two
side panels.
Reattach all floor levelers. Use the
included screwdriver to again tighten
the set screws.
Carefully lift the showcase vertically
with your assistant.

Fit the bottom cabinet’s base into the
case.
Fit the base of the showcase area
into the case.
Insert light panel diagonally from
inside case*. Lower right rear corner
(side with switch) to bottom lip, then
lower left rear corner. Once both
sides are in place, lower front side
(panel opposite door). Connect wire
output from showcase to light panel
wires.
Place the top panel of the showcase
so the holes line up with the lights for
ventilation.
Insert the three tempered glass
shelves. If needed, adjust height of
shelf clips with included screwdriver.
Your showcase is now complete and
ready to be filled with merchandise!
*Please Note: Repetitive insertion of light panel may cause small chips to the laminate covering of the
panel. These damages are small and are hidden once the panel is in place.