Dogtra 2500T series User manual

1
2500T&B
AVAILABLE IN 2-DOG SYSTEM: 2502T&B
Owner's Manual
Please read this manual thoroughly
before operating the 2500T&B
Training and Beeper e-collar.

2
IMPORTANT SAFETY AND PRODUCT
INFORMATION
WARNING
Please read all safety and product information below
before using your Dogtra product. Failure to follow
these safety instructions could result in injury to you,
your dog and others, or it could result in damage to your
Dogtra product or other property.
PRODUCT SAFETY
Training Methods
Dogtra products may be used with a variety of training
methods. However, each dog may have a different reaction
to training methods and to Dogtra products. Closely
observe your dog when determining the right training
method to use with your Dogtra product.
Aggressive Dogs
Do not use Dogtra products with aggressive dogs as such
dogs may react adversely and cause injury to people or
other dogs. Seek the assistance of a dog-training specialist
or veterinarian when dealing with aggressive dogs.
Children
Dogtra products are not toys. Adult supervision and close
attention are necessary when Dogtra products are used by
or near children.
PRODUCT DAMAGE
Electrical Product
Your Dogtra product contains electrical components and
batteries. Do not use or keep your product near heat or
flammable sources. Such use or storage may damage your

3
product and/or cause fire, explosion, injury, or property
damage.
Medical Device Interference
Dogtra products contain electrical and magnetic
components that emit low level electromagnetic waves and
radio frequencies. These electromagnetic waves or radio
frequencies may interfere with pacemakers, defibrillators,
or other medical devices. Consult your physician or
medical device maker before using your medical device
with a Dogtra product. If you think that your Dogtra
product is interfering with your pacemaker, defibrillator,
or other medical device, stop using the Dogtra product.
Inadvertent Activation
The digital microprocessor offers thousands of unique
codes to eliminate frequency match-up with other Dogtra
e-collars. The Constant button will automatically shut
down after being held down for 12 seconds or more as a
safety feature.
UNAUTHORIZED USE
Your Dogtra product should be used only in a humane
manner to train and educate your dog. Dogtra products
are not intended for use in any other manner nor are they
intended for use with other animals or with humans.
BATTERY
Your Dogtra product contains batteries. Take care when
removing and installing batteries as your fingers may get
caught. Dispose of batteries as provided by your local
regulations. Do not disassemble, crush, heat, or otherwise
alter the battery as it may cause fire, injury or property
damage.

4
CONTENTS
MAIN FEATURES .............................................................
PACKAGE CONTENTS ...................................................
DESCRIPTION OF TRANSMITTER PARTS ................
TRANSMITTER BUTTON FUNCTION .........................
DESCRIPTION OF RECEIVER PARTS ........................
CHARGING THE BATTERY ...........................................
TESTING YOUR 2500T&B ............................................
RECEIVER FITTING ........................................................
MAXIMIZING THE DISTANCE ......................................
MAINTENANCE ...............................................................
TROUBLESHOOTING GUIDE .......................................
WARRANTY AND REPAIR INFORMATION ..............
5
7
8
18
22
26
28
30
32
33
34
37

5
• Easy-to-use, ergonomically fitted transmitter
• Rheostat Dial that allows for gradual adjustments in
stimulation intensity with no jumps between levels
(0-127 levels)
• Two-dog models allow the trainer to control two
different dogs from one transmitter
• 1-mile range
• 2 different stimulation types - Nick & Constant
• 400-yard audible remote-controlled beeper
• The freedom to choose between a high and low pitch
beeper (single-dog unit only)
• Three beeper modes - Run/Point, Point-Only, and
Locate
• Innovative beeper volume control that lets you select
between 2 different pitches and 3 volume levels for each
pitch
• Combines the receiver with the beeper horn into one
small, compact unit
• 2-hour rapid charge lithium polymer batteries
• Fully waterproof receiver and transmitter
• No bothersome external antenna on the receiver
• One-charging system allows the transmitter and
receiver(s) to be charged at the same time
MAIN FEATURES

6
• Easily visible blue LCD screen displays the exact level of
stimulation that can be seen in the dark
• A three bar battery life indicator and LED colored
indicator to show the remaining battery life

7
• Transmitter
• Receiver (two receivers for Dogtra two-dog models)
• Lithium Polymer Battery charger and splitter cable
• Test light
• Owner’s manual
• Carrying case
• Metal belt clip accessory
PACKAGE CONTENTS

8
DESCRIPTION OF
TRANSMITTER PARTS
Antenna
Beeper Pitch
Toggle Switch
On/Off
Button
Nick
Constant
LCD
Screen
Rheostat Dial
On/Off
Magnetic
Red Dot
Battery Charging
Receptacle &
Rubber Plug
LED
Indicator
Light
Locate
Mode
2500T&B
Transmitter (1-dog)

9
DESCRIPTION OF
TRANSMITTER PARTS
Antenna
1st Dog
/2nd Dog
Toggle Switch
On/Off
Button
Nick
Constant
LCD
Screen
Rheostat Dial
On/Off
Magnetic
Red Dot
Battery Charging
Receptacle &
Rubber Plug
LED
Indicator
Light
Locate
Mode
2502T&B
Transmitter (2-dog)

10
Transmitter Antenna
A 3.2” antenna is supplied with the 2500T&B Series
transmitter. The antenna must be fastened to the
transmitter before using the unit.

11
Beeper Pitch Toggle Switch on the One-Dog Models
2500T&B
The one-dog model has a beeper pitch toggle switch on
the face of the transmitter located above the Nick button,
which is designed to easily select a beeper pitch, either
High or Low.
Set the toggle switch on the High position to select the
High pitch and the Low position to select the Low pitch.
Beeper Pitch
Toggle Switch

12
1st Dog/2nd Dog Switch on the Two-Dog Models
2502T&B
The two-dog model has a toggle switch on the face of
the transmitter located above the Nick button. The toggle
switch allows for selection of either receiver.
Set the toggle switch on the green position to select
the green receiver and the orange position to select the
orange receiver. Stimulation (Nick and Constant) along
with the beeper and locate modes will only operate when
the toggle is in the desired position for the appropriate
receiver.
1st Dog/2nd
Dog Toggle
Switch

13
Rheostat Dial
The Rheostat Dial is located on the top of the transmitter:
(0) being the lowest level and (127) being the highest. The
LCD screen on the transmitter indicates the intensity level
and battery life.

14
LCD Screen
The LCD screen indicates the stimulation level on the
screen ranging from (0-127). The battery life indicator
shows:
3 bars = full charge
2 bars = medium charge
1 bar = needs charge
When pressing the MODE button, the selected beeper
volume level is shown on the LCD (Note: Pressing the
Mode button once will also set the unit in the Run/Point
mode). When the toggle switch is set on low pitch the LCD
will read: L1= lowest volume, L2 = medium volume and L3
= highest volume. When the toggle switch is set on high
pitch, the LCD will read: H1 = lowest volume, H2 = medium
volume and H3 = highest volume.

15
Care for LCD Transmitters in Cold Temperature
In cold temperatures (10°F or below), the Liquid Crystal
Display (LCD) on your transmitter may be dim or slow to
respond. Wait until the display becomes visible before
selecting any training level. Even though the LCD screen
might be dim or slow to respond when you push the
Nick or Constant button, the transmitter will still function
properly. In the occurrence of extremely cold weather,
the LCD screen might take a moment to respond causing
the intensity level to freeze at that current level. In this
situation, if you turn the Rheostat Dial, the level on the
screen may not change but the actual intensity from the
receiver will change in agreement with the dial. In this
situation, it is ideal to either wait until your transmitter
is back to working order before emitting a correction, or
while holding the Constant button down slowly turn the
Rheostat Dial while watching your dog’s, reaction. Do not
turn the Rheostat Dial rapidly, because the receiver will
emit a static correction based on the level of the Rheostat
Dial, which might not be correctly reflected on the LCD
screen.
Attention!
When using the unit in cold temperatures, it is
recommended that the transmitter is placed under
your jacket next to your body. The warmth of your
body will greatly improve the battery life and usage.

16
Transmitter LED Indicator
The transmitter LED indicator light is located near the
Rheostat Dial. It will flash every 4 seconds when the
transmitter has been turned on. The color of the light
indicates the status of battery life. It flashes green when
the battery is fully charged and turns to amber when the
battery is at medium charge. It is acceptable to charge
your unit even at medium charge without any damage
incurred to your collar. When the transmitter indicator
emits a blinking red light, the battery needs to be
recharged.
Green = Full charge
Amber = Medium charge
Red = Needs charge

17
Transmitter Battery Charging Receptacle & Rubber Plug
Located on the backside of the transmitter, the charging
receptacle is covered by a rubber plug. Insert one end of
the battery charging cable into the receptacle to charge
the battery.
After charging is completed, close the receptacle with
its rubber plug to make sure dirt or water does not get
inside.
*The unit will be fully waterproof with or without the
rubber plug.

18
TRANSMITTER BUTTON FUNCTION
Beeper Pitch
Toggle Switch
Nick
Constant
Locate
Mode
On/Off
Button
The transmitter for the Dogtra 2500T&B Series has five
buttons (two on the face of the transmitter, two on the
left side, and one on the right side).
Nick Button
When the Nick button is pushed, the receiver emits a
single rapid pulse of electrical stimulation.
Constant Button
Pressing the Constant button gives continuous stimulation
as long as the button is pushed, for up to 12 seconds. If
the button is not released after 12 seconds, the stimulation
will automatically turn off as a safety feature. The receiver
will be ready to be reactivated once the button has been
released.
Locate Button
The Locate button is located on the left side. It causes
the receiver's beeper horn to emit a series of beeps when
pushed and it gives you the ability to keep track of your
dog’s location. On one-dog models, the beeper can be
adjusted between high and low pitches.

19
NOTE: The high/low pitch is not an option on two dog
units. On two-dog models, the green receiver emits the
high pitch and the orange receiver emits the low pitch
automatically. The pitch cannot be changed.
Mode Button
Your 2500T&B has three different modes: Locate, Run/
Point, and Point-Only. The Locate mode can be activated
at any time, even when another mode is set, by pressing
the top orange button labeled Locate on the left side of
the transmitter.
When you press the Mode button the first time, the
receiver will beep twice. The beeper unit will always start
in Run/Point mode. The beeper will sound every 7 seconds
while the dog is running, and every 2 seconds when the
dog is on point or becomes stationary. The second time
you push the Mode button, it will beep once and remain
silent while the dog is running and beep every 2 seconds
when the dog is on point or stationary. To turn the beeper
unit off, press the Mode button a third time. The unit will
emit three rapid beeps, and the beeper will turn off. The
Locate mode can still be used! When the 2500T&B toggle
switch is set on low pitch, the beeper will emit a double
beep when it is in Run/Point mode or Point-Only mode.
If the toggle switch is set on the high pitch, a single beep
will sound when using Run/Point or Point-Only mode.

20
NOTE: The Locate button can be used in any mode you
are in.
Initial Beeper
Sound Mode Action
Press 1st
Time 2 Beeps Run/Point
Mode
- Dog running: Double
beep every 7 seconds.
- Dog on-point: Double
beep every 2 seconds.
Press 2nd
Time 1 Beep Point-Only
Mode
- Dog running : Remains
Silent.
- Dog on-point : Double
beep every 2 seconds
Press 3rd
Time 3 Beeps Beeper No sound