Dogtra YS 200 User manual

By Dogtra No Bark Collars
1. The YS200 is intended to prevent the barking of
dogs only. It is NOT intended for use on people or on
animals other than dogs. Dogtra does not assume any
liability for the improper use of the YS200.
2. Leaving the YS200 in the same position on a dog’s
neck for over 8 hours at a time can cause skin
irritation. Occasionally reposition the unit so the
contact points are moved to a different location on
the dog’s neck. Dogtra is not responsible for skin
irritation caused by the prolonged usage of the
YS200.
3. A proper t is necessary for the YS200 to work
optimally. Both contact points must be in contact
with your dog’s skin at all times for a consistent
stimulation. A loose tting collar can cause the
contact points to rub against the skin and cause
irritation.
4. The YS200 is not intended for use on dogs less than 1
year old.
5. Remove the YS200 before playing with your dog. The
activity may cause your dog to bark, which could
lead to the association of playing to the electrical
stimulation.
6. Closely monitor your dog’s activity and stimulation
output while using the YS200. When attaching or
removing the YS200 from your dog’s neck, make
sure your dog is not barking and in a calm or stable
condition.
Intensity
Levels 1-6
6
Water Resistant
Receiver
Reduced Size
Collar
Replaceable
Battery
3V 3V
Vocal Cord
Sensor
Main Features
At a GlanceProduct Safety and Health Statement
YS200
No Bark
Collar
(2)Coin Lithium
Batteries
(3V CR2032)
13mm
Contact
Points
Owner’s
Manual
NOTICE
Start with the lowest level of stimulation and work your
way up. An appropriate level is when your dog responds
to the stimulation with a mild negative reaction, such as a
jerking or tensing of the neck muscles.
How to Use the On/Off & Intensity Dial
+
-
The ON/OFF and
Intensity Dial is used to
turn the YS200 on and
off, and to select the
intensity level. Set the
dial to OFF to turn off
the YS200. Set the no bark collar to (1) for the lowest
stimulation setting and (6) for the highest stimulation
setting.
Overview
ON/OFF and
Intensity Dial
LED Indicator Light
Collar Strap
Contact
Points Battery Cover
Testing the YS200
1. Turn the intensity dial to
level 2 or 3.
2. Use the cap end of
a ballpoint pen and
repeatedly tap between
the contact points.
3. The unit is working once
the LED indicator blinks. Wait 2 seconds and tap again.
4. The unit is in normal working condition when the LED
indicator blinks again. The LED indicator will only
blink when the unit is activated.
Replacing the Batteries
*Turn the unit off before attempting to replace the batteries.
- Use a coin to unscrew the battery cover counterclockwise.
- Insert two batteries with the plus sides facing out
(both batteries must be facing the same direction).
- Replace the battery cover by screwing it in clockwise. Be
sure to place the batteries with the ‘+’ sides facing up and
out. To remove the batteries, remove the battery cover
and tap the batteries on the palm of your hand.
Batteries
+
-
Owner's
Manual
For Dogs as
Small as 5 lbs

It is important to have a
proper t for safe and
consistent results.
- Place the YS200 to the
left or right of your dog’s
vocal cords.
- Both contact points must
touch your dog’s skin to properly operate.
- When properly tted, you should be able to t a nger
or two snugly in between the contact points and your
dog’s sk i n.
*Caution : Remove all other collars when using the
YS200. Other collars or buckles may cause the YS200
to inadvertently activate.
Fitting the YS200
Troubleshooting Guide
Extended Contact Points
1. My dog has skin irritation.
- This may be due to an improper t or leaving the collar
in the same location for an extended period of time. If
your dog exhibits signs of skin irritation, consult with a
veterinarian.
2. My dog is not reacting to the YS200.
- Check the LED indicator while testing the unit. If the
LED indicator does not come on, the batteries may need
to be replaced.
- Tighten the collar strap around your dog’s neck if it
is too loose and make sure the contact points are held
rmly against the dog’s skin.
- If your dog has a thick or long coat and you already have
the extended contact points, you may need to trim the
hair on your dog’s neck so that both contact points are
touching your dog’s skin.
3. I need to clean the YS200.
- To clean the YS200, make sure the battery cover is
closed and fully sealed, and wipe down the unit with
a damp cloth and some alcohol. Make sure the unit is
completely dry before use.
WARRANTY AND REPAIR
INFORMATION
1-Year Comprehensive Warranty
Dogtra Company provides the original purchaser with a
1-YEAR WARRANTY for the iQ Pet Series, eF-3000 Gold,
RR Deluxe, YS200, YS300, YS500, and YS600. The warranty
begins from the date of purchase. For the rst year, coverage
is for Parts, Labor, and Accessories.
After the rst year, the cost of Parts, Accessories, Labor fees,
and Shipping fees incurred are the customer’s responsibility.
Labor fees will be variable depending on the extent of the
work required.
To Qualify for the Dogtra Warranty
All products must be registered and/or a proof of purchase is
required to initiate repair work under warranty. Registration
must be completed within 30 days of purchase. If you were
unable to register your product within 30 days of purchase, we
will accept all products for repair with a proof of purchase.
We strongly recommend keeping the original receipt. If your
product is not registered and a proof of purchase is not
available at the time of service, Dogtra will estimate the age of
the unit by the serial number. Serial number estimates can
differ from the actual purchase date. A serial number estimate
is the only method of determining an approximate date of
purchase without product registration or a proof of purchase.
Extended contact points are
available for purchase for
dogs with long and/or thick
coats. Both contact points
must touch your dog’s skin
and may require longer contact points if your dog has a
long and/or thick coat.
Not Covered Under Warranty
Dogtra DOES NOT offer warranty for products that have
been bought secondhand or as a resold product. Dogtra
DOES NOT replace defective units or provide refunds
for products purchased from us after 30 days from the
date of purchase. Dogtra DOES NOT cover the cost of
shipping outside of the Continental United States. Issues of
replacement and refunds on units purchased less than 30 days
from an authorized dealer must be addressed to the dealer
directly. If the products purchased from an authorized dealer
are after 30 days from the date of purchase, please send the
units to Dogtra for service and repair. Dogtra DOES NOT
cover the cost of repairs and replacements due to misuse by
the owner or dog, improper maintenance, and/or lost units.
Any water damage on the Water Resistant Transmitters of
the 175NCP, 180NCP, 200NCP Series, 1400NCP Series,
1500NCP Series, and iQ Pet Series, and the Water Resistant
Receivers of the RRS, RRD, and RR Deluxe, will not be
covered. All replacement costs for either the transmitter or
receiver will be the owner’s responsibility. The warranty is
void if the unit has been altered or an unauthorized person
has damaged the unit while attempting repair work. Battery
replacement by the customer during the rst year of the
2-year Limited Lifetime Warranty is not recommended. If
the customer chooses to replace the batteries, any damage
to the unit during the change-out by the owner will void the
warranty.
The removal of serial numbers from any Dogtra products
will void the warranty. Dogtra reserves the right to retain
and discard any parts or accessories that have been found
damaged upon replacement and repair.
Procedure for Repair Work
The cost of shipping products under warranty back to Dogtra
is the customer’s responsibility. Dogtra is not responsible for
units damaged or lost in transition to Dogtra. Dogtra is not
responsible for loss of training time or inconvenience while
the unit is in for repair work. Dogtra does not provide loaner
units or any form of compensation during the repair period.
A copy of the sales receipt showing the purchase date may be
required before warranty work is initiated. Please include a
brief explanation outlining the problem and include your
name, address, city/state/zip code, daytime phone number,
evening phone number, and email address. If the repair costs
are not covered under warranty, we will call you for payment
information and authorization.
The diagrams and representations in the manual may differ
slightly from the actual product depending on the model type.
Discover other pet supplies on our website.