4
Adjustable Collar: Your receiver comes fitte to an a justable nylon collar. The
collar shoul be positione above the og’s regular collar. The collar shoul be
a juste to insure that the contact posts touch the skin on the og’s neck. Check the
fit for the first few ays of wear to insure that the collar is not too tight or causing
irritation to your pet’s neck.
DogWatch recommends that you remove the collar at night while your pet is inside.
SafeLink®Digital FM Design: Our patente FM esign allows the DogWatch
receiver to recognize an activate only to our unique ra io signal. This protects your
pet from unintentional correction cause by stray ra io signals which may be emitte
by other electronic evices.
AutoMemory™:Our patente AutoMemory feature automatically a justs the
correction level of the receiver when your pet challenges the boun ary. When the
receiver is set to one of the AutoMemory levels, an the og enters the signal fiel ,
the og will receive the correction of the initial setting. If your og leaves the signal
fiel , the receiver will automatically a vance the correction level setting by one, an
only one level. If the og oes not re-enter the signal fiel within the next 24-hour
perio , the receiver efaults to the original setting. The AutoMemory feature operates
when your Receiver Training Level is set to 4, 5, or 6.
FastReact™ Time: The DogWatch receiver offers the fastest reaction time available
in the pet containment in ustry. Whether your og, strolls, runs or sprints into the
Avoi ance Zone, the receiver will react — an correct — within 1/8 of a secon (.125).
Automatic Shutdown: The DogWatch system is esigne to protect your og from
an over-correction in the unlikely event that your og gets caught in the signal fiel . If
your og oes not exit the signal fiel , the receiver will automatically stop correcting
after 15 secon s — protecting your og from over-correction. The receiver will
automatically reset once the og leaves the signal fiel .
CollarBone: The CollarBone, metal lock washers an contact posts fasten the
receiver to the nylon collar. The plastic “collar bone” is esigne to fit two collar
5
boun ary wire is broken or the signal is interrupte , the Loop in icator light will go
out an an au ible warning will soun . If the Loop light is out, consult your Dealer.
You shoul also check aroun your property for a visible broken wire.
6. Loop Monitor Display (LMD): The Loop Monitor Display provi es a visual
in ication of the status of your boun ary signal. On tra itional boun ary wire
configurations each number on the scale represents the boun ary signal istance
in feet, that is being broa cast from each si e of the wire. A significant change
( rop) in signal range coul in icate a partial wire break or other boun ary wire
problem. Contact your ealer for troubleshooting tips or to sche ule an
appointment.
Note: For non-tra itional wire configurations where the boun ary wires may be
close to one another, the LMD may not measure the boun ary signal accurately in
feet, but is a visual setting reference point. Your DogWatch ealer will explain the
LMD setting an your actual signal range.
7. Range: The ra io signal is transmitte from the boun ary wire in all irections. The
signal is a juste by the range control on the transmitter to create a signal fiel on
each si e of the wire. The recommen e signal fiel wi th is 6-10 feet. Your
DogWatch Dealer will a just the ra io signal istance accor ing to the personality
an traits of your og. Consult your DogWatch Dealer first before making any
a justments yourself.
Signal Field: The signal fiel has two areas. When your og first enters the signal
fiel , he will receive an au ible warning. If he continues further into the signal fiel ,
he will receive a correction. The au ible area is approximately the first 13% of the
total signal fiel . To prevent your og from entering the signal fiel an remaining in
the au ible area causing epletion of the battery, the receiver will transition from an
au ible warning to a short warning correction after a perio of 15 secon s. This will
activate regar less of the mo e switch setting, but will not activate if the receiver is
in the “Au ible Only” Training Level (see Phase 1: page 15)
. Training Mode: The training mo e switch allows you to choose between two pet
frien ly training options: Basic (Mo e A) an QuickAlertTM (Mo e B). When in the
Basic setting, your pet will receive an au ible warning followe by a correction. For
har er to train ogs, when set to QuickAlert, your pet will receive a very quick
“alert” correction followe by the normal au ible warning an correction.
If you have multiple ogs on the system, when you set the training mo e on the
transmitter, it will effect all receivers.
9. Rate: This a justs to three levels (1 = slow, 2 = me ium, 3 = fast). When your og
gets a correction, he receives it in a series of pulses. Increasing the Rate means
that he will receive a greater number of pulses per secon . The Rate feature
operates when your Receiver Training Level is set to Level 1, 2, or 3.
See the Receiver Levels and Transmitter Settings chart on page 9
Note: On the back of the transmitter are four small switches. These switches
set your transmitter to the correct broa cast frequency. Your ealer will set
these switches for your system.
Do NOT change these settings. They are for DEALER USE ONLY.
Adjustable
Nylon
Collar
Test Light
Magnet
Contact Posts
3.6 Volt Battery (R )
Battery Cap
Hold Magnet Between Two Lines
Metal Lock
Washer
CollarBone
R7 and R8 Receiver Features
The lightweight radio receiver worn by the dog identifies the coded FM radio signal from
the boundary wire. It creates an audible warning followed by stimulation if he comes too
close to the boundary wire. It operates on a replaceable battery and is waterproof when
the battery cap is securely fastened.