Dräger Perseus A500 Quick start guide

D-41942-2012
Dräger Perseus® A500 Breathing System
Disassembly/Assembly
Disassembly
Unscrew the CLIC adapter.
Screw the CLIC adapter.
Insert the cleaning disk into the
adapter. Close the adapter so
that it engages.
Remove the cleaning disk from the
adapter. Close the adapter so that
it engages.
Remove the ow sensors.
Loosen and pull out the
inspiratory port.
Screw off the APL valve.
Align the APL valve correctly and
tighten it with the knurled nut.
Lift off the upper part of the
breathing system.
Remove the valves
(red and blue).
Assembly
Push in the expiratory port and
tighten it with the knurled nut.
Loosen and pull out the
expiration port.
Turn the three levers
counterclockwise about 120°.
91 02 842 | 16.09-4 | HQ | HO | Subject to modications | © 2016 Drägerwerk AG & Co. KGaA
Place the upper part of the
breathing system on the lower part.
Turn the three levers clockwise
about 120°.
Push in the inspiratory port and
tighten it with the knurled nut. Insert the ow sensors.
Align the valves correctly.
Insert the valves.

D-41942-2012
Dräger Perseus® A500 Breathing System
Reprocessing Instructions
The following parts must be free of deposits:
– Incident ow grills
– Non-return valves (red and blue)
If required, remove deposits on the valve
plates of the non-return valves with a soft
cloth. If the incident ow grills are damaged,
contact DrägerService®.
* For machine cleaning, position each valve
so that the valve cage is at the bottom.
Visual check
Manual cleaning
and disinfection
Machine cleaning
and disinfection
Sterilization
Position components so that all interior spaces and surfaces are completely ushed and water can drain off freely.
This guideline does not replace the instruction for use.
*