DRAGONFIRE 04-0045 User manual

DragonFire
Slayer Sport Side Mirrors
Part # 04-0045 Multiple Vehicles
Congratulations on your purchase of DragonFire Racing Sport Side Mirrors! Now YOU can check on your buddies eating your
dust with the stylish side mirrors. Adjustable and off-road ready.
Disclaimer
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty of representation is made as to the products
ability to protect the user from any injury or death. The user assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by
the customer hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise.
• Read and understand these instructions before installing product
• Installation may scratch powder coat or paint
• Improper installation may result in unsatisfactory viewing angle
• Do not use product if there are any signs of damage
Tools Required
4mm Allen Bit or Wrench
Ratchet
Pre-installation: Lay out components and compare to list and images.
Part & Hardware List
ITEM QTY SIZE LENGTH TYPE STEP USED
P1 1 - - Slayer SS Mirror LH* All
P2 1 - - Slayer SS Mirror RH* All
P3 2 - - Rubber Pad Insert 4
P4 2 - - Indicator Disk (Extra)
*Driver and Passenger Mirror will be determined by the logo in the correct orientation.
P1
P2
P3
Note: An assistant may be needed to hold the product in place during installation.
P4

Step 1: Place vehicle on a at and level surface. Place gear selector in “Park” and remove keys from the ignition.
Step 2: With the 4mm Allen wrench, remove 2 bolts on the side from the mount of the Sport Side Mirror [P1 or P2] (Figure A). Set the bolts and
clamp band aside for next step.
Step 3: Place mirror and clamp band onto the frame of the vehicle at the desired location (Figure B). Loosely tighten the 2 bolts removed in
Step 2.
Step 4: Place a Rubber Pad Insert [P3] where shown (Figure C).
Step 5: Position the mirror at the desired height. While holding rubber pad in place, tighten middle bolt (shown by arrow) until clamp is secured
(Figure D).
Step 6: Rotate mirror to desired position on the frame and then tighten the 2 bolts on the side until secured (Figure E).
Step 7: Loosen the middle bolt just enough to rotate mirror on the clamp. Do Not uninstall bolt completely. Adjust mirror to desired position and
then tighten the middle bolt until secured (Figure F).
Step 8: When mirror is at the desired height and viewing angle, check to ensure all bolts are
securely tightened (Figure G). Repeat installation instructions for opposite side Sport
Side Mirror.
Step 9: This completes installation. Time to ride and enjoy!
ProTip: Periodically check all hardware and re-tighten if needed.
DragonFire Racing puts everything within reach. Learn more about powersports frame & body we have.