DRAGONFIRE RacePace 01-2110 User manual

Dragonfire Racing
Maverick & Maverick Max RacePace Rear Smash Bumper Installation Instructions
Part # 01-2110 (Black - Non DS Models)
01-2111 (Red - Non DS Models)
01-2127 (Octane Blue - Non DS Models)
01-2131 (Manta Green - Non DS Models)
Congratulations on your purchase of the DragonFire RacePace Rear Smash Bumper for the Maverick &
Maverick Max. Designed not only to look good, this bumper offers supreme protection as well as support
for rear plastics. Like everything we do we won’t make something unless it improves what you have.
Accelerate your Maverick to RacePace!
*This product does not promise rear end protection in the event of a collision
*Improper installation may result in damage to vehicle
*This product is not intended as an anchor point for pulling
*Do not use if there is any sign of damage
Disclaimer
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death.
No warranty of representation is made as to the products ability to protect the user from any injury
or death. The user assumes that risk. The acceptance and /or use of this merchandise purchased
from DragonFire by the customer hereby shall release DragonFire from any and all liability
pertaining to the use of such merchandise.
Step 1: Place vehicle on flat/level surface.
Place gear shifter in park and remove
keys from the ignition.
Step 2: With floor jack, lift rear of the
vehicle up and secure with jack stands.
Step 3: Remove the top two bolts
retaining the rear a-arms. Set hardware
aside it will be re-used. See Figure A
Tools Required
(2) 13mm Wrench
(2) 15mm Wrench
10mm Wrench
7mm Socket
Number 30 Torx
Bit
DragonFire Racing
3191 N. Washington St. Suite 2
Chandler, AZ 85225
1 [phone]
WWW.DRAGONFIRERACING.COM

Dragonfire Racing
Step 4: Remove the rear factory plastic
support bracket. Retain the outer two
screws; they will be re-installed after
bracket has been removed. See Figure B
& C above for reference
Step 5: Remove rear plastic panel by
removing mounting screw on backside of
panel. Set hardware aside it will be re-
used. In some cases aftermarket exhaust
will need to be removed for installation of
the rear bumper. See Figure D
Step 6: Remove outer two screws from
taillight plastics. Set hardware aside it will
be re-used. See Figure E

Dragonfire Racing
Step 7: Place rear bumper into position and
secure top mount with supplied hardware.
Leave loose at this time. See Figure F
Step 8: Re-install factory hardware
previously removed in step 3 on lower a-
arm mounts, retaining lower bumper
mount. (If you are installing with rear receiver
hitch mount, bumper will set on top of hitch
plates) See Figure G
Step 9: Secure all bumper mounting
hardware to factory torque specs provided
in owner’s manual.
Step 10: Place outer fender support tabs
behind factory plastics, align with hole
where hardware was previously removed in
step 6. Secure into place using this same
hardware. See Figure H
ProTip: Check all hardware periodically and re-tighten if needed
For further assistance please contact your authorized DragonFire dealer