DRAGONFIRE RacePace 01-3801 User manual

DragonFire
DragonFire Racing
3191 N Washington St. Suite 2
Chandler, AZ 85225
1 [phone]
http://www.DragonFireRacing.com
Revision No: 01
Revision Date: 11/08/2018
RacePace Front Bumper
Part # 01-3801 Textron Wildcat XX Black
Part # 01-3811 Textron Wildcat XX Gray
Congratulations on your purchase of the DragonFire Race Pace Front Bumper. Your UTV now has front end protection, while
also riding in style!!! Be sure to check out the full line of DragonFire Accessories for your Wildcat XX at your local authorized
dealer or online at http://www.DragonFireRacing.com
Disclaimer
Off road activities can be hazardous and could
lead to injury, dismemberment, paralysis and
death. No warranty of representation is made
as to the products ability to protect the user
from any injury or death. The user assumes
that risk. The acceptance and /or use of this
merchandise purchased from DragonFire by
the customer hereby shall release DragonFire
from any and all liability pertaining to the use
of such merchandise.
• Read and understand these instructions before installing product
• This product does not promise front end protection in the event of a collision
• This product is not intended as an anchor point for pulling
• Do not use product if there are any signs of damage
Tools Required
Socket Wrench
19mm Socket
Pre-installation: Lay out components and compare to list and images. Images may not portray the full detail or exact
shape of the parts; however, they represent parts that have same or similar function.
Refer to DragonFire Racing Website for ensure that you have the latest revision of instructions & templates.
Part & Hardware List
ITEM QTY SIZE LENGTH TYPE STEP USED
P1 1 - - Front Bumper 4
P2 4 M12 x 1.25 20mm Hex Head Bolts 3 & 4
P3 4 M12 - Split Lock Washer 3 & 4
P4 4 M12 - Flat Washer 3 &4
P2
P1
P3
P4

DragonFire
Step 1: Place vehicle on a at and level surface. Place gear selector in “Park” and remove keys from the ignition.
Step 2: Identify the 4 Mounting points on the front end of the vehicle (Figure A).
Step 3: Place the lock washer [P3] onto the bolt [P2] rst, then the at washer [P4] (Figure B).
Step 4: Install the Front Bumper [P1] by threading the hardware into the mounting points (Figure C). Tighten using the 19mm socket.
Step 5: Torque M12 hardware to 85 ± 10 N-m (63 ± 7 ft-lbs). Figure D shows the properly
installed Front Bumper.
Step 6: This completes installation. Time to ride and enjoy!
ProTip: Periodically check all hardware and re-tighten if needed.
For further assistance please contact us at
customerservice@dragonreracing.com or 1-800-708-9803.