DRAGONFIRE 11-0800 User manual

DragonFire Racing
3191 N. Washington St. Suite 2
Chandler, AZ 85225
1 [phone]
WWW.DRAGONFIRERACING.COM
DragonFire Universal LED Chase Light
Part # 11-0800 27” LED Chase Light Black Housing
Part # 11-0801 36” LED Chase Light Black Housing
Congratulations on your purchase of the DragonFire Universal LED
Chase Light! Make sure to check additional DragonFire products for
your UTV at your local Authorized DragonFire Dealer or online at
http://www.DragonFireRacing.com .
•Read and understand these instructions before installing product
•Check Local Law/Requirements before use
•Never drive under the influence
Disclaimer
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty
of representation is made as to the products ability to protect the user from any injury or death. The user
assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer
hereby shall release DragonFire from any and all liability pertaining to the use of suchmerchandise.

Step 1: Place vehicle on a flat and level surface. Place gear selector in “Park”
and remove keys from the ignition.
Step 2: Locate the desired chase light mounting point on your vehicle. We
recommend that the Chase Light be installed on the rear of the vehicle,
either on the Roll Cage, or the back of the roof, facing the back, and
high enough to be seen. Mount the chase light with the Logo facing up,
using the 2 screws on the back of the chase light, or the supplied
brackets. As Shown on Figure A. We recommend using our Universal
Clamps (Part Number # 11-0036) for increased versatility (Sold
Separately). As Shown on Figure B.
Step 3: Locate the tail light cables, and test each one of them using a multi-
meter to determine the brake light. You will need to turn the ignition key
to auxiliary in order for the tail lights to turn on. The multi-meter/ Test-
Light should not display power until pressing down the brake pedal.
Step 4: Once the power wire is identified, tap into the brake light cable using a
connector (Not Included), or solder the yellow wire with a green stripe
from the chase light to the brake light cable. View Figure C. The Blue
(Right Turn) and Brown (Left Turn) wires are optional turn signal wires.
View Figure D for reference. Our turn signal kit is sold separately.
Part & Hardware List
Item
QTY
Description
Step Used
P1
1
Chase Light with Cables
Step 2
P2
1
Push Button Cycle Switch
Step 6
P3
1
Rocker Switch
Step 5
P4
2
Battery Terminals
Step 5
P5
4
4mm x .7 Screws
Step 2
P6
2
Mounting Brackets
Step 2
Tools Required
Phillips Screw Driver
Digital Multi-Meter/ Test-Light
Socket Wrench
Razor Knife
.56”Drill Bit (9/16”)
Mounting Bolts

Step 5: Run the Rocker Switch wire harness to the dashboard. Connect the wires to the rocker switch, then install the rocker
switch on your dashboard. Recommended hole size for the Rocker Switch is 1.43” x .850”.The rocker switch powers
the Chase Light. Connect the Battery Terminal Cables to the battery. Figure E shows how the rocker switch should be
connected.
Step 6: Run the Push Button Cycle Switch wire harness to the dashboard. Drill a hole on your dashboard with a .56” Drill Bit,
and install the Push Button Cycle Switch on your dashboard. The Push Button changes the Flashing Amber Light
pattern. There are a total of 7 patterns to choose from. Figure G shows the Push button Cycle Switch.
Note: Chase Light Diagram displayed in Figure F.
For further assistance please contact us at
[email protected], or by phone at
1-800-708-9803.