Drive DeVilbiss Healthcare AutoFold Elite User manual

AutoFold Elite Scooter
QUICK START GUIDE
Follow the instructions below to quickly and
safely set up and start your scooter.
Issue 2021-03 Rev1
1. Unpack the scooter, as shown above. You will have the
following parts:
1 x scooter unit
1 x battery pack
2 x keys
1 x remote fob
2 x armrest
2 x threaded knob for armrest
1 x charger and mains cable
2. Plug the mains lead into the charger, and then plug the
round connector from the charger into the charging socket of
the scooter.
Finally switch the charger on at the mains.
3. Insert the key into the ignition (as shown below) and switch
the scooter on. Then press the button marked “A - Open”
for 1 second. The scooter will then slowly beep and unfold.
For safety, the unfold process will stop halfway. Press the
button again to fully unfold the scooter. When fully unfolded
the scooter will emit three quick beeps.
4. Insert the battery pack as shown below.
5. Flip the backrest into position.
PLEASE TURN OVER

6. Pull on the catch (arrowed) on the tiller to unlock. Then pull
up the tiller until it is set at the correct height for the user.
Push the catch to lock the tiller.
7. Adjust the tiller angle by pressing the lever (arrowed) whilst
pulling or pushing the tiller to the correct angle. Release the
lever to lock the tiller in position.
8. Insert the armrest into the receiver.
Note: The angle of the armrest may need adjusting.
Please refer to the procedure on page 21
9. Secure the armrest by screwing the threaded knob into the
hole (arrowed).
10. Remove the protective film wrapping on each of the four
tyres (not shown). This only needs performing the first
time the scooter is set up.
11.Insert the key into the ignition and turn to start the scooter.
12.CHARGE BEFORE USE
Plug the mains lead into the charger, and then
plug the round connector from the charger into
the charging socket of the scooter.
Finally switch the charger on at the mains.
The scooter can be charged either unfolded or
folded (refer to user manual for folding
instructions).