DT Research DT313SC Assembly instructions

INTRODUCTION
Thank you for acquiring the DT313SC/ DT313T, part of DT Research’s line of rugged
tablets. Featuring a slim, robust enclosure, the DT313SC/ DT313T with a 13.3”
TFT display is powered by the Intel® processor, oering opmal combinaons of
performance and power savings.
The DT313SC/ DT313T is available with Microso® Windows® operang system. Each
soware operang system features web browser, client/ server compung soware,
media player, accessories, and applicaons support.
PACKAGE CONTENTS
One DT313SC/ DT313T with Baery Pack and Handstrap
AC-DC Power Adapter with Power Cord
Basic Operaon Guide
* If your DT313SC/ DT313T contains Barcode Scanner or Front/Back Camera modules, please refer
to the Tablet Modules Basic Operaon Guide for detailed operaon.
ENGLISH 8
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
Copyright © 2019, DT Research, Inc. All Rights Reserved. BOG 051719313TENG
Federal Communicaon Commission Interference
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protecon against harmful interference in a residenal
installaon. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instrucons, may
cause harmful interference to radio communicaons. However, there is no
guarantee that interference will not occur in a parcular installaon. If this
equipment does cause harmful interference to radio or television recepon,
which can be determined by turning the equipment oand on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operaon.
This device and its antenna(s) must not be co-located or operang in
conjuncon with any other antenna or transmier.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.

ENGLISH 2
Buon Funcons
BUTTON ACTION
Programmable buon
Power buon
Trigger buon
Baery latch
Input/ Output Ports
Ethernet Port
HDMI-out
USB 2.0 Port
Headphone-out
USB 3.0 Port
DC-in
The DT313SC/ DT313T
1
2
A
B
C
D
Baery/Power LED
3
4
E
F
1
2
4
3
B
A
C
D
E
F
3ENGLISH
Power/Baery LED Status:
Blue indicates the baery is 25% to 100% charged
Blinking blue indicates the baery is charging
Orange indicates that the baery is between 11% to 25%
Blinking Orange indicates that the baery is below 10%
Precauons
Always exercise care when operang and handling the DT313SC/ DT313T.
Do NOT apply excessive pressure to the display screen.
We recommend using the Digital Pen (oponal) to keep the screen clean.
Avoid prolonged exposure of the display panel to any strong heat source. Wherever
possible, the DT313SC/ DT313T should face away from direct light to reduce glare.
If the AC-DC power adapter is used to recharge or power the tablet, do NOT use any
AC-DC adapter other than the one provided or acquired from the manufacturer or its
partners.
In the unlikely event that smoke, abnormal noise, or strange odor is present,
immediately power othe DT313SC/ DT313T and disconnect all power sources.
Report the problem to your device provider immediately.
Never aempt to disassemble the DT313SC/ DT313T, as this will void the warranty.
THE DT313SC/ DT313T
Basic Features
The DT313SC/ DT313T wireless tablet integrates a bright and mul-touch display, one
USB port, and embedded networking elements such as wireless LAN and Bluetooth.
The DT313SC/ DT313T is complemented by a suite of accessories, including baery
expansion, charging cradles, and baery charger kit, for a comprehensive user
experience.
A DT313SC/ DT313T typically integrates an 802.11ac wireless LAN (WLAN) adapter that
may connect to other wireless devices or access points. If your DT313SC/ DT313T does
not come with such a network adapter, please consult your device provider to establish
the desired network connecvity.

5ENGLISH
Start Up
If the power up (from Standby or otherwise) is successful, the appropriate interface will
be displayed aer a launch sequence of several seconds. The wireless LAN connecon
may take 10-15 seconds to be established.
Conguring the Mobile Tablet
The DT313SC/ DT313T may be congured using the ulies and methods dictated by
the soware operang system. The DT313SC/ DT313T should be congurable for various
properes such as user proles, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT313SC/ DT313T is oen delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidden custom antenna.
Through the support of typical WLAN adapters, the DT313SC/ DT313T should be able
to detect all 802.11 access points in the vicinity for you to select the access point of
your choice for connecon.
The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT313SC/ DT313T and
the access points have to match. The SSID is case-sensive and it is recommended
that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves) for secure
access.
When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly congure
associated sengs such as Authencaon mode, etc.
Refer to the access point operang manuals for seng up the 802.11 access points.
OPERATION
Powering ON and OFF
To acvate the DT313SC/ DT313T, push and quickly release the Power Buon. The
display will come on in a few seconds. To put the DT313SC/ DT313T in Standby mode,
push and quickly release the Power Buon. To turn the DT313SC/ DT313T ofor
extended storage, power osafely using any soware funcon that “shuts down
computer”provided in the soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power—please use
the AC-DC adapter with the DT313SC/ DT313T when seng up for the rst me
to fully charge the internal baery pack. You may charge the external baery
pack with it aached to the DT313SC/ DT313T, or with the oponal external
baery charger kit.
NOTE:
When the baery pack(s) is (are) charging, the blue-colored Baery LED should
blink slowly. If plugging in the AC-DC adapter does not trigger this blinking
acvity and the LED stays dark, the baery pack(s) may have been drained
substanally. Try unplugging/ replugging the AC-DC adapter to the DT313SC/
DT313T a few mes to acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in “Standby”mode while not in use. Pushing briey on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (“hold 4+ seconds”feature) to turn othe
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.
ENGLISH 4

7ENGLISH
To Hold the Tablet
Lehand: grip the leback side of the tablet
with your lehand four index ngers, with thumb
resng on the top of the back side of the tablet
and palm securely against the back.
Right hand: grip the right back side of the tablet
with your right hand four index ngers, with
thumb resng on the top of the back side of the
tablet and palm securely against the back.
ENGLISH 6
Bluetooth
The DT313SC/ DT313T oers the Bluetooth module which supports Bluetooth 4.0
standard including Bluetooth 3.0 High Speed and Bluetooth 4.0 Low Energy, which
delivers faster speeds (up to 300 Mbps) with low power consumpon.
USING THE MOBILE TABLET
Peripherals Support
Through its USB port, the DT313SC/ DT313T supports a wide range of USB-based
peripherals. These peripherals are applicable for soware installaon, applicaons
storage, data storage, and system soware recovery and updates. DT313SC/ DT313T is
also compable with custom mountable cradle opons. These securable and mountable
cradles provide an interface to VESA mounts and arms, and to ports that may include
USB, Ethernet, and pass-through power.
For More Support
Users can download the Tablet Modules Basic Operaon Guides from the DT Research
website.