EAST COAST Toulouse Single Bed User guide

Assembly and care
instructions
Toulouse
Single Bed

IMPORTANT!
READ CAREFULLY AND KEEP FOR
FUTURE REFERENCE
Thank you for purchasing an East Coast product. It’s been carefully designed and constructed to oer
quality, safety and reliability for you and your baby.
If you have a query about this product or require replacement parts, please contact 01692 408802.
Your child’s safety is your responsibility. Keep children clear during assembly as the fittings pack contains
small parts which may present a choking hazard. Please read the instructions and warnings carefully
before use.
You will need the following tools to complete assembly: cross-point screwdriver & flat-head screwdriver
Lay out the parts on a soft level surface and compare to the parts checklist. Don’t throw away any
packaging until you’re sure that you have all the parts.
Parts
Hardware
1
Head and foot
boards
Base slats
Side rails
Dowel x 4 Bolt x 8 Barrel nut x 8
Screw x 8 Hexagon key

Assembly 1
2
Barrel
nut x 2
Dowel
Fit dowels to the ends of the side rails as shown
(4 dowels) and push barrel nuts into the holes in
the inner faces of the rails. Using a flat-head screw
driver, make sure that the holes in the barrel nuts
line up with the holes in the ends of the side rails.
Attach the headboard and footboard to the side
rails and secure using the eight bolts. Tighten using
the hexagon key provided.
Bolt x 4
Assembly 2 Screw x 4
Note: Repeat
for other side.
With the fabric tapes on the underside of the wooden slats, lay the base slats on the assembled frame
so that they rest on the supporting batten on the inside of the side rails.
Position one end slat at the end of the batten and secure in place using two screws.
Pull the opposite end slat so that it lines up with the other end of the battens and secure using two
more screws. Assistance may be required to help complete this step.
Finally secure the two inner slats using the remaining four screws.
Before use, check that all fixings are tight.
Note: Ensure each end slat
is in line with the end of the
supporting batten.
Note: Repeat for other end

Care and maintenance
In use
For customer care or enquiries:
Call: ([phone]
Email: [e-mail]
East Coast Nursery Ltd. Robertson House, North Walsham,
Norfolk, NR28 0BX
eastcoastnursery.co.uk EC_TSB_121118
All assembly fittings should be tightened properly and should be checked regularly and re-tightened as
necessary. Take care when moving the furniture, as careless handling may cause damage.
Cleaning is simple; just wipe over with a damp cloth, and avoid using strong detergents or abrasives.
An occasional light application of a wax polish will help maintain the finish.
WARNING: YOUR CHILDREN’S SAFETY IS YOUR RESPONSIBILITY
Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not be
placed too close to other furniture or windows, blind cords, curtain pulls or other strings or cords. It
should either be placed tightly against any wall or have a gap of 300mm between the wall and the side
of the bed.
This bed is to be used with a 1900mm x 900mm mattress.
Warning: This bed is not suitable for children under 4 years old.
Warning: Do not use the bed if any part is broken, torn or missing and use only spare parts approved
by the manufacturer.
Warning: Be aware of the risk of open fires and other sources of strong heat, such as electric bar fires,
gas fires, etc. near the vicinity of the bed.
Warning: Do not place the child’s bed near heat sources, windows or other furniture.
This product can be dismantled carefully for storage and transportation, but once the base has been
assembled this should not be taken apart.
This product has been designed and manufactured to: BS 8509: 2008 +A1: 2011.