EAST COAST Devon Dresser User manual

Devon
Dresser

Important
Retain for future reference: Read carefully
Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation
of this product.
Your child’s safety is your responsibility. If you have a query with this product or require replacement
parts, please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist on pages 2 and 3. Do
not discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking hazard.
You will need the following tools to complete assembly:
Flat-headed screwdriver and Cross point screwdriver.
2
Hardware
J x 6
H x 12
(25mm)
E x 2
B x 6
A x 6
D x 2
G x 12
(35mm)
C x 14
I x 32
(15mm)
F x 12
K x 6
Hexagon Key x 1

3
Wooden Parts
290 mm
230 mm
300 mm
Changer Back
Changer Cover
Changer Front
Changer Surface
Dresser Side 1
Dresser Side 2
Back Panel (Upper)
Back Panel (Lower)
Drawer Back x 3
Drawer Baser x 3
Centre Crossbar
Lower Front Crossbar
Lower Rear Crossbar
Drawer Brace x 3
Drawer Side x 3 (L & R)
Drawer Front (Top)
Drawer Front (Bottom)
Drawer Front (Centre)

Assembly 1
Assembly 2
4
Dresser Side 1
E
D
NOTE: Take care to insert the dowels
into the correct holes as indicated.
Repeat for the opposite end of each
crossbar. (Total 14 x part C)
Changer Front
Changer Front
Changer Back
Centre Crossbar
Lower Front Crossbar
B
A
Changer Back
Centre Crossbar
Lower Rear Crossbar
Lower Front Crossbar
Lower Rear Crossbar
C x 7

E
D
Changer Surface
Assembly 3
Assembly 4
5
B
A
Dresser Side 2

NOTE:
Ensure that the slot in the Back
Panel (Upper) is at the top.
I x 16
I x 16
Assembly 5
Back Panel (Upper)
Back Panel (Lower)
Assembly 6
6
Drawer Front (Top)
Drawer Side (R)
Drawer Side (L)
H x 2
H x 2
NOTE:
Repeat for remaining Drawer
Sides and Drawer Fronts

Assembly 8
7
F x 4
Assembly 7
Drawer Base
Drawer Brace
Drawer Back
NOTE:
Ensure slots in part F are visible.
Repeat for remaining drawers.
NOTE:
Repeat for remaining drawers.

J x 2
K x 2
Assembly 10
8
Assembly 9
G x 4
NOTE:
Repeat for remaining drawers.
NOTE:
Repeat for remaining drawers.

Assembly 11
Top drawer
Centre drawer
Bottom drawer
Assembly 12
Changer Cover
Nappy Storage
NOTE:
The Changer Cover
must not be fitted
when using as a
changing unit. Store
safely.
Ensure that the
Changer Cover is
securely located on
the top of the unit
when using as a
dresser.
9

10
Assembly 13
The dresser is supplied with a fixing kit which will secure it and help to guard against accidental tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place the dresser against the wall where it is to be fitted. Mark the wall at the centre of the upper crossbar.
Move the dresser away.
2. Using the 25mm screw, washer and the appropriate wall fixing attach the fabric strap to the marked position.
3. Replace the dresser and attach the strap to the centre of the rear crossbar using the 15mm screw and the
washer.
Before use, ensure that the strap is securely fixed to both the wall and the dresser.
Washer x 2
Screw (15mm)
Screw (25mm)
Plastic wall plug
(for brick and masonry wall use only)
Fabric strap
1
2
3
The type of wall fixing you will require depends on the construction of the wall. See below for details. If in doubt,
seek professional advice.
Wood: If fixing to wood make
sure that it isn’t chipboard as
screws can easily pull away
the core structure.
Brick or masonry: Use the
wall plug, provided you are
sure that your wall is sound.
Cavity wall: Special toggle
wall plugs needed.
Seek expert advice.

BLANK PAGE
11

Care & Maintenance
Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Regularly check that all fixings are tightened and that there are no broken or damaged parts.
In use
Warning: Do not leave your child unattended.
All assembly fixings should always be tightened properly. Care should be taken that no screws are
loose because a child could trap parts of their body, or clothing (e.g. strings, necklaces, ribbons,
dummies, etc.) which could pose a risk of strangulation.
Be aware of the risks of open fires and other such sources of strong heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the dresser.
Do not use as a changing unit when the Changer Cover is fitted.
Suitable for use with a flat changing mat 76 x 47 cm which does not compromise the effective height of
the changer barriers.
The changing area is suitable for use up to 12 months old or 11kg in weight.
Do not use the dresser if any of the parts are broken, torn or missing.
Any additional or replacement parts can only be obtained from the manufacturer or the distributor.
Customer Care line for this Product 01692 408802
7843-02
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk, NR28 0BX
www.eastcoastnursery.co.uk