EAST COAST Montreal User manual

MONTREAL
Dresser

Important
Retain for future reference: Read carefully
Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation of
this product.
Your child’s safety is your responsibility. If you have a query with this product or require replacement parts,
please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist on pages 2 and 3. Do not
discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking hazard.
You will need the following tools to complete assembly:
Flat-headed screwdriver and Cross point screwdriver.
2
Hardware
A x 36
B x 2
C x 2
D x 27
E x 6
G x 11
(30mm)
H x 15
(45mm)
I x 6
(60mm)
K x 28
Hexagon
Key x 1
J x 6
F x 12

3
Wooden Parts
Changer Side x 2
Changer Back
Changer Front
Top Panel
Lower rear Crossbar
Upper Rear Crossbar
Upper Front Crossbar
Plain Crossbar x 3
Side Panel x 2
Base
Drawer Side (L&R) x 3
Drawer Front x 3
Drawer Base x 3
Drawer Back x 3
Back Panel x 2
Drawer Brace x 3

4
A x 24
All Crossbars
A x 2
Side Panel
NOTE: Take care to insert the dowels into
the correct holes as indicated. Repeat for
the opposite end of each crossbar. (Total
24 dowels)
Assembly 1
Assembly 2
Repeat for the opposite panel. (Total 4
dowels)

Assembly 3
Assembly 4
5
H x 15
(45mm)
H
F
H x 2
Plain Crossbar x 3
Upper Front Crossbar
Upper Rear Crossbar
Lower Rear Crossbar
I x 3
Base

6
Assembly 6
G x 5
H
Top Panel
H x 6
F x 6
I x 3
Assembly 5

Assembly 8
7
Assembly 7
NOTE: Slot to top
Back Panel
Back Panel
K x 28
Drawer Front
Drawer Side (R)
Drawer Side (L)
Drawer Back
Drawer Base
Drawer Brace
D x 9
Repeat for other 2 drawers

Assembly 10
Changer Back
Changer Front
Changer Side (x 2)
B (each end)
A x 2
(each end)
A x 2
8
Assembly 9
E x 2
Handle

Assembly 12
G x 2
G x 2
9
NOTE:
Insert Cam Nut (Part C) with arrowed
slot facing the Changer Front.
To lock Changer Front in place, turn
Cam nuts (part C) 1/2 turn clockwise
with a large flat-bladed screwdriver
after assembly.
Assembly 11
G x 2
C x 2
Changer Front
Changer Side
Changer Back
Changer Side

The dresser is supplied with a fixing kit which will secure it and help to guard against accidental tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place dresser against the wall where it is to be fitted. Mark the wall 25mm (1”) down from the top
surface of the changer.
2. Using the 25mm screw, washer and the appropriate wall fixing attach the fabric strap to the marked
position.
3. Remove the top drawer and thread the free end of the strap through the slot in the back panel.
4. From the inside of the dresser, attach the fabric strap to the dresser frame using the 15mm screw and
the washer.
Refit the top drawer.
Before use, ensure that the strap is securely fixed to both the wall and the dresser.
1
234
The type of wall fixing you will require depends on the construction of the wall. See below for details.
If in doubt, seek professional advice.
Wood: If fixing to wood make
sure that it isn’t chipboard as
screws can easily pull away
the core structure.
Brick or masonry: Use
the wall plug, provided
you are sure that your
wall is sound.
Cavity wall: Special toggle
wall plugs needed.
Seek expert advice.
Washer x 2
Fabric strap
Plastic wall plug
(For brick or masonry wall use only)
Screw (25mm)Screw (15mm)
10
Assembly 13

11

Care & Maintenance
Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Regularly check that all fixings are tightened and that there are no broken or damaged parts.
In use
Warning: Do not leave your child unattended.
All assembly fixings should always be tightened properly. Care should be taken that no screws are loose
because a child could trap parts of their body, or clothing (e.g. strings, necklaces, ribbons, dummies, etc.)
which could pose a risk of strangulation.
Be aware of the risks of open fires and other such sources of strong heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the dresser.
Suitable for use with a flat changing mat 75 x 47 cm which does not compromise the effective height of the
changer barriers.
The changing area is suitable for use up to 12 months old or 11kg in weight.
Do not use the dresser if any of the parts are broken, torn or missing.
Any additional or replacement parts can only be obtained from the manufacturer or the distributor.
Customer Care Hotline For this Product 01692 408802
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk,
NR28 0BX
6898-2