EAST COAST Montreal User manual

MONTREAL
Two door Wardrobe

Small Bolt (24mm) x 4
Please read the instructions and warnings carefully before use to ensure safe and satisfactory
operation of this product.
Your child’s safety is your responsibility. If you have a query with this product or require replacement
parts, please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist on pages 2 and 3. Do
not discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking
hazard.
You will need the following tools to complete assembly:
Flat-headed screwdriver and Cross point screwdriver.
2
IMPORTANT
RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
Handle x 4
Cam Nut x 4
Large Bolt (70mm) x 6Medium Bolt (27mm) x 28
Hexagon key
Dowel x 12Short Woodscrew x 60Long Woodscrew x 8 Medium Woodscrew x 12
Hinge x 6
Cam Pin x 4
Hardware:
A
B
Before assembling the Wardrobe,
note that some of the joints use
Cam pins A, screwed into one part,
secured by Cam nuts B inserted
into the large hole in the mating
part.
The Cam nut is secured by aligning
the arrow on its surface with the
Cam pin, inserting into the hole,
and rotating approximately half a
turn with a large flat bladed screw-
driver.

Parts:
Side panel x 2
Door x 2
Lower shelf
Upper shelf
Drawer Back
Drawer Front
Rear frame x 2
Left Drawer Side
Large back panel x 2
Small back panel x 2
Clothes rail
Lower frame
Top panel
Drawer Base
3
Rear crossbar
Front Crossbar x 2
Right Drawer Side

NOTE: Take care to insert the dowels into the correct holes as indicated. Repeat for the opposite end
of each crossbar. (Total 12 dowels)
4
NOTE: Do not fully tighten the bolts at this stage.
You may find it easier to complete the following 4 stages of the assembly with the Side lying flat on
the floor or other soft level surface.
Wardrobe Assembly 2. Assembling top and bottom frames.
Wardrobe Assembly 1. Fitting the Dowels.
Top panel
Top panel
Rear crossbar
Front Crossbar x 2
Medium Bolt (27mm) x 2
Medium Bolt (27mm) x 2
Rear frame
Rear frame
Lower frame

NOTE: Repeat for second Side panel
5
Side panel
Side panel
Wardrobe Assembly 3. Fitting the Cam pins.
Wardrobe Assembly 4. Fitting the top and bottom frames.
Medium Bolt (27mm) x 4
Rear frame
Cam Pin x 4
Large Bolt (70mm) x 3

Wardrobe Assembly 6. Fitting the Shelves.
6
Wardrobe Assembly 5. Fitting the crossbars.
NOTES:
Ensure that the Front crossbars have the large holes in its ends facing downward.
Attach the Crossbars by inserting Cam Nuts, making sure that the arrow on one of the screwdriver
slots points to the nearest edge of the part. To secure the parts, turn the Cam Nut approximately 1/2
turn clockwise until resistance is felt.
Medium Bolt (27mm) x 6
Medium Bolt (27mm) x 2
Medium Bolt (27mm) x 2
Rear crossbar
Front Crossbar
Upper shelf
Lower shelf
Front Crossbar
Cam Nut x 2

NOTE: Fit the bolts as shown then stand the wardrobe up on a level surface for the remaining
assembly steps
7
Wardrobe Assembly 7. Attaching the second Side panel.
Wardrobe Assembly 8. Securing the second side panel.
NOTE:
Ensure all dowels are located in the correct holes in the second Side panel
Side panel
Cam Nut x 2
Medium Bolt (27mm) x 3
Medium Bolt (27mm) x 5
Large Bolt (70mm) x 3

NOTES:
Fit the two Medium bolts before attaching the Back panels
Fit the top Small back panel first, making sure that the slot is at the top edge.
Stand the wardrobe in its final position and ensure that all bolts are fully tightened.
8
Slot at top edge
Wardrobe Assembly 9. Fitting the back panels.
Large back panel
Large back panel
Small back panel
Small back panel
Medium Bolt (27mm) x 2
Short Woodscrew x 14
Short Woodscrew x 16
Short Woodscrew x 14
Short Woodscrew x 16

NOTE:
Repeat for second door
9
Long Woodscrew x 4
Long Woodscrew x 4
Right Drawer Side
Left Drawer Side
Drawer Base
Drawer Front
Drawer Back
Wardrobe Assembly 10. Assembling the drawer.
Wardrobe Assembly 11. Fitting the handles and hinges.
Small Bolt (24mm) x 3
Door
Handle
Handle x 2
Medium Woodscrew x 6
Hinge x 3

Screw A
Door
Side panel
Screw B
With the wardrobe in its final position, the doors can be fitted.
Locate screw A on the hinge in the slot on the hinge plate attached to the Side panel
The doors can be adjusted to fit by adjusting screws A and B in the rear part of each hinge to alter
the angle and fit of each door in its frame.
Fit the drawer to the wardrobe by lifting its front edge slightly and placing the plastic wheels at the
rear of the drawer into the metal channels on the wardrobe Side panels. Lower the front of the
drawer and push the drawer into the recess.
Wardrobe Assembly 12. Fitting and adjusting the doors.
10

11
Wardrobe assembly 13. Fitting the safety strap
The Wardrobe is supplied with a fixing kit which will secure it and help to guard against accidental
tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place Wardrobe against the wall where it is to be fitted. Mark the wall 25mm (1”) down from the top
of the wardrobe.
2. Using the 25mm screw, washer and the appropriate wall fixing attach the fabric strap to the
marked position.
3. Open the door and thread the free end of the strap through the slot in the back panel.
4. From the inside of the Wardrobe, attach the fabric strap to the underside of the Top panel using the
15mm screw and the washer.
Before use, ensure that the strap is securely fixed to both the wall and the Wardrobe.
1 2 3 4
The type of wall fixing you will require depends on the construction of the wall. See below for details. If
in doubt, seek professional advice.
Wood: If fixing to wood make
sure that it isn’t chipboard as
screws can easily pull away
the core structure.
Brick or masonry: Use
the wall plug, provided
you are sure that your
wall is sound.
Cavity wall: Special toggle
wall plugs needed.
Seek expert advice.
Washer x 2
Fabric strap
Plastic wall plug
(For brick or masonry wall use only)
Screw (25mm)Screw (15mm)

Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Regularly check that all fixings are tightened and that there are no broken or damaged parts.
• WARNING! Your child’s safety is your responsibility.
• The wardrobe must be used on a level and stable surface.
• Discourage your child from climbing on or playing with this wardrobe as it is not a toy.
• Glue is not included but can be used at your discretion on dowelled joints to further strengthen the
wardrobe.
• Once assembled, it is inadvisable to disassemble the wardrobe.
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk,
NR28 0BX
Customer Care Hotline For this Product 01692 408802
12
5002/2
CARE AND MAINTENANCE
IN USE