EAST COAST TOULOUSE User manual

Toulouse
Wardrobe

Hardware
2
G x 9
(25mm)
B x 14
(45mm)
E x 14
J x 2
A x 4
(50mm)
C x 15
(25mm)
L x 6
D x 32
H x 12
(15mm)
F x 6
Hexagon Key x 1
I x 76
(12mm)
Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation
of this product.
Your child’s safety is your responsibility. If you have a query with this product or require replacement
parts, please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist on pages 2 and 3. Do
not discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking hazard.
You will need the following tools to complete assembly:
Cross-point screwdriver.
Important
Retain for future reference: Read carefully
K x 2

Wooden Parts
3
Centre Rear Crossbar
Plain Crossbar (Wide) x 2
Clothes Rail x 2
Front Crossbar
Plain Crossbar (Narrow) x 2
Wardrobe Side x 2 (L & R)
Back Panel (Small) x 2
Trim Panel
Door x 2
Drawer Brace
Top Panel
Drawer Back
Drawer Base
Shelf
Drawer Front
Drawer Side x 2 (L & R)
Rear Crossbar (With Holes) x 2
Back Panel (Large) x 2

Assembly 1
Assembly 2
4
E
B
Front Crossbar
Plain Crossbar (Wide)
Plain Crossbar (Narrow)
Rear Crossbar (With Holes)
Centre Rear Crossbar
Plain Crossbar (Narrow)
Plain Crossbar (Wide)
Wardrobe Side
NOTE: Take care to insert the dowels
into the correct holes as indicated.
Repeat for the opposite end of each
part. (Total 32 x part C)
D x 16
Front Crossbar
Centre Rear Crossbar
Plain Crossbar (Wide)
Plain Crossbar (Narrow) x 2
7 locations
Rear Crossbar (With Holes)
Rear Crossbar (With Holes) x 2
NOTE:
Fit "Rear Crossbar (With Holes)" and
"Plain Crossbar (Narrow)" with the larger
recessed hole toward the feet of the wardrobe.

Shelf
Wardrobe Side
7 locations
B
E
C x 6
Assembly 4
Assembly 3
5
A x 2

C x 3
Trim Panel
Top Panel
C x 6
Top Panel
A x 2
Assembly 5
Assembly 6
6

7
NOTE:
This stage is best carried out with the Wardrobe laid on its front on a soft surface.
1. Place each Back Panel into the recess on the back of the Wardrobe in the positions
shown in the diagram.
2. Secure each Back Panel in place with screws I.
I x 76
Back Panel (Large)
Back Panel (Small)
Assembly 7
Back Panel (Large)
Back Panel (Small)

Assembly 9
Assembly 8
Assembly 10
G x 4
8
Drawer Side
Drawer Side
Drawer Front
Drawer Base
Drawer Brace
Drawer Back

Assembly 11
Assembly 12
Completed Drawer
F x 4
G x 5
9
J x 2
Clothes Rail
Clothes Rail

10
Assembly 13
The wardrobe is supplied with a fixing kit which will secure it and help to guard against accidental tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place the wardrobe against the wall where it is to be fitted. Mark the wall at the centre of the top edge of the
wardrobe. Move the wardrobe away.
2. Using the 25mm screw, washer and the appropriate wall fixing, attach the fabric strap to the marked position.
3. Re-position the wardrobe. Attach the strap to the top of the wardrobe using the 15mm screw and the washer.
4. Proceed to Assembly 14 to fit and adjust the doors.
Before use, ensure that the strap is securely fixed to both the wall and the wardrobe.
Washer x 2
Screw (15mm)
Screw (25mm)
Plastic wall plug
(for brick and masonry wall use only)
Fabric strap
1
2
3
The type of wall fixing you will require depends on the construction of the wall. See below for details. If in doubt,
seek professional advice:
Wood: If fixing to wood make
sure that it isn’t chipboard as
screws can easily pull away
the core structure.
Brick or masonry: Use the
wall plug, provided you are
sure that your wall is sound.
Cavity wall: Special toggle
wall plugs needed.
Seek expert advice.

Assembly 14
Assembly 15
K x 1
F x 1
H x 2
(6 total)
L (3 total)
Door
NOTE:
Repeat for second Door.
Screw 1
Screw 2
NOTE:
To adjust the fit of the doors in the frame,
position the wardrobe where it will be
used and use screws 1 and 2:
Screw 1 loosens the hinge to move the
door forward or backward.
Screw 2 moves the door closer to, or
further from the frame.
1.
2.
11

Customer Care line for this Product 01692 408802
7840-03
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk, NR28 0BX
www.eastcoastnursery.co.uk
Care & Maintenance
Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Regularly check that all fixings are tightened and that there are no broken or damaged parts.
In use
All assembly fixings should always be tightened properly.
Be aware of the risks of open fires and other such sources of strong heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the wardrobe.
Do not use if any of the parts are broken, torn or missing.
Any additional or replacement parts can only be obtained from the manufacturer or the distributor.
Only use the wardrobe on a stable and level surface.
Ensure that the wall strap is used to securely attach the wardrobe to the wall to prevent tipping.