EAST COAST TOULOUSE User manual

TOULOUSE
Dresser

2
Important
Retain for future reference: Read carefully
Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation
of this product.
Your child’s safety is your responsibility. If you have a query with this product or require replacement
parts, please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist on pages 2 and 3. Do
not discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking hazard.
You will need the following tools to complete assembly:
Flat-headed screwdriver and cross-point screwdriver.
Hardware
Hexagon Key
x 1
A x 16
B x 13
C x 48
G x 27
(25mm)
I x 12
J x 6
D x 5
E x 5
F x 14
H x 28
(15mm)

3
Wooden Parts
Changer Side 1
Changer Divider 2
Changer Divider 1
Changer Side 2
Changer Front
Changer Rear
Lower Back Panel
Dresser Top
Drawer Back x 3
Twin Drawer Front
Single Drawer Front x 2
Front Crossbar
Drawer Side x 6 (L X R)
Drawer Brace x 3
Drawer Base x 3
Plain Crossbar x 4
Side Panel x 2 (L & R)
Upper Back Panel
Upper Rear Crossbar
Upper Front Crossbar

4
Upper Front Crossbar
Upper Rear Crossbar
NOTE: Take care to insert the dowels into the correct
holes as indicated. Repeat for the opposite end of
each crossbar. (Total 28 x part C)
Assembly 1
Assembly 2
Front Crossbar
Plain Crossbar x 4
Upper Front Crossbar
Plain Crossbar
Upper Rear Crossbar
Plain Crossbar
Plain Crossbar
Plain Crossbar
Front Crossbar
F
A
NOTE:
Secure all Crossbars using
Parts A and F (1 each per
Crossbar) as shown.
Side Panel
C x 14

5
Assembly 3
Assembly 4
D x 5
F
A
NOTE:
Secure Crossbars using Parts
A and F (1 each per Crossbar)
as shown.
Side Panel
Changer Front
Changer Divider 1
Changer Side 2

6
Assembly 6
Assembly 5
C x 8
C x 8
Changer Divider 1
Changer Side 2
Changer Side 1
Changer Divider 2
B x 2
Changer Side 2
Changer Side 1
Dresser Top
Changer Divider 2
Changer Divider 1
Assembly 7
E x 2

7
Assembly 9
Assembly 8
Changer Front
E x 3
B x 5
Changer Rear

8
NOTE:
Ensure the Dresser
Top is assembled
as shown.
Changer Front
Front Crossbar
Assembly 11
Assembly 10
C x 4
Dresser Top
B x 3
B x 3
A x 2

9
Assembly 12
Upper Back Panel (Slot at top)
H x 14
Assembly 13
Assembly 14
G x 2
G x 2
H x 14
Lower Back Panel
NOTE:
Repeat for remaining drawers.
NOTE:
Repeat for remaining drawers.
Twin Drawer Front
Drawer Side
Drawer Side
Drawer Base

10
Assembly 15
Assembly 16
Assembly 17
Drawer Back
Drawer Brace
G x 2
G x 3
I x 4
J x 2
NOTE:
Repeat for
remaining
drawers.
NOTE:
Repeat for
remaining
drawers.
Twin Drawer Front
Single Drawer Front
Single Drawer Front

11
Assembly 18
The dresser is supplied with a fixing kit which will secure it and help to guard against accidental tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place the dresser against the wall where it is to be fitted. Remove the top drawer and mark the wall through
the slot in the Upper Back Panel.
2. Move the dresser away and using the 25mm screw, washer and the appropriate wall fixing attach the fabric
strap to the marked position.
3. Replace the dresser and thread the fabric strap through the slot in the Upper Back Panel.
4. Attach the fabric strap to the Upper Rear Crossbar using the 15mm screw and the washer.
5. Replace the top drawer.
Before use, ensure that the strap is securely fixed to both the wall and the dresser.
Washer x 2
Screw (15mm)
Screw (25mm)
Plastic wall plug
(for brick and masonry wall use only)
Fabric strap
1
2
4
The type of wall fixing you will require depends on the construction of the wall. See below for details. If in doubt,
seek professional advice.
Wood: If fixing to wood make
sure that it isn’t chipboard as
screws can easily pull away
the core structure.
Brick or masonry: Use the
wall plug, provided you are
sure that your wall is sound.
Cavity wall: Special toggle
wall plugs needed.
Seek expert advice.

Care & Maintenance
Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Regularly check that all fixings are tightened and that there are no broken or damaged parts.
In use
Warning: Do not leave your child unattended.
All assembly fixings should always be tightened properly. Care should be taken that no screws are
loose because a child could trap parts of their body, or clothing (e.g. strings, necklaces, ribbons,
dummies, etc.) which could pose a risk of strangulation.
Be aware of the risks of open fires and other such sources of strong heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the dresser.
Suitable for use with a flat changing mat 76 x 47 cm which does not compromise the effective height of
the changer barriers.
The changing area is suitable for use up to 12 months old or 11kg in weight.
When changing your child ensure anything stored in the separate compartments on top of the dresser is
kept out of reach of your child.
Do not use the dresser if any of the parts are broken, torn or missing.
Any additional or replacement parts can only be obtained from the manufacturer or the distributor.
Customer Care line for this Product 01692 408802
7839-02
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk, NR28 0BX
www.eastcoastnursery.co.uk