EAST COAST Moses User manual

Folding
Moses basket Stand

2
IMPORTANT. Read the instructions carefully before
use and keep for future reference.
Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation
of this product.
The stand must be fully erected and locked before your carry cot is placed into it.
This product has been designed and manufactured to: BSEN 1466:2014
The stand is designed for a carry cot with maximum dimensions at the base of 800 x 320mm and a
minimum of 670 x 270mm
Your child’s safety is your responsibility. If you have a query with this product or require replacement
parts, please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist below. Do not discard
any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking hazard.
Hardware
C x 2
D x 2
Hexagon Key
x 2
A x 1
B x 1
E x 2

3
Assembly 1
NOTE:
Ensure that the metal Locksafe® bar is
the right way up as shown.
Repeat for other side.
Tighten using the two
supplied hexagon keys.
Check regularly and
re-tighten as necessary.
D
C
E
B
A
Assembly 2

Assembly 3
4
Customer Care line For this Product 01692 408802
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk, NR28 0BX
www.eastcoastnursery.co.uk 7558-3
Safety
WARNING - YOUR CHILDREN’S SAFETY IS YOUR RESPONSIBILITY.
WARNING - Use only on a firm ground which is horizontal, level and dry.
WARNING - Do not let other children play unattended near the carry cot and stand.
WARNING - Do not use if any part of the stand is broken, damaged or missing.
Use only replacement parts supplied or approved by the retailer or manufacturer.
Do not place carry cot and stand in close proximity to a wall or other obstacle; this is intended to prevent
entrapment.
The stand is not intended for use as a bath stand and should not be used for any other purpose than as
a carry cot stand.
Do not rock the carry cot whilst in the stand.
Do not allow older children to use it as a toy or climbing frame.
When not in use the stand should be folded and stored safely away from children.
Maintenance
All assembly fittings should be tightened properly and should be checked regularly and re-tightened as
necessary.
Cleaning
The metal Locksafe® mechanism can be cleaned with a damp cloth (and wipe dry). The frame can be
wax polished.
Do not use abrasives cleaners or bleach.
Ensure that the metal Locksafe®
bar is securely located over the
wooden dowel before use.
UK Patent No. 2344511