EAST COAST Acre Wardrobe User guide

Assembly and care
instructions
Acre
Wardrobe

IMPORTANT
RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY
Thank you for purchasing an East Coast product. It’s been carefully designed and constructed to oer
quality, safety and reliability for you and your baby.
If you have a query about this product or require replacement parts, please contact 01692 408802.
Your child’s safety is your responsibility. Keep children clear during assembly as the fittings pack contains
small parts which may present a choking hazard. Please read the instructions and warnings carefully
before use.
Lay out the parts on a soft level surface and compare to the parts checklist. Don’t throw away any
packaging until you’re sure that you have all the parts.
You will need the following tools to complete assembly:
Flat-headed screwdriver and Cross-point screwdriver
Hardware
1
A x 3 B x 3 C x 16 D x 2 (30mm)
Hexagon Key x 1
E x 6 F x 8 G x 30 H x 20
I x 2 J x 2 K x 12

2
Wardrobe Parts
Wardrobe
topper
Wardrobe
top
Rear leg
Rear
crossbar
Hanging
rail (2)
Wardrobe
door (L & R)
Side panel
(L & R)
Back
panel
joiner
strip
Wardrobe base
panel
Back
panel
(2)
Front leg

Assembly 1
Assembly 2
H x 7
C x 4
NOTE:
Repeat process to secure the Front leg to the
Wardrobe base panel.
Do not tighten bolts fully until assembly is complete.
NOTE:
Repeat process for opposite side(s).
3
Front leg
Wardrobe
base panel
Wardrobe
base panel
Rear
crossbar
Rear leg

Assembly 3
Assembly 4
C x 4
4
Rear
crossbar
Right side
panel
Base and
leg assembly
C x 4
Left side
panel

Assembly 5
Assembly 6
H x 4
F x 8
Wardrobe
top
5
NOTE:
Ensure that the Wardrobe top is the correct way
round, with the pre-attached block at the front
of the wardrobe.

Assembly 7
Assembly 8
6
I x 2
B x 3
Wardrobe
topper

Assembly 9
Assembly 10
A x 3
Wardrobe
topper
7
H x 2

Assembly 11
Assembly 12
G x 15 G x 15
Back panel Back panel
Back panel
joiner strip
8
x2 K per
hinge
E x 3 per
door
NOTE:
Repeat process for Left wardrobe door.
Right
wardrobe
door

Assembly 13
1. The narrow part of the front
screw fits into the slot in the
metal plate on the wardrobe side.
2. The slot in the hinge fits under
the rear screw head. (You may
need to loosen the screw first).
NOTE:
Repeat process for Left wardrobe
door.
Right
wardrobe
door
1.
2.
Metal
plate
Hinge
9

Assembly 14
Assembly 15
NOTE:
Once the wardrobe is in position, use the screws
on the hinges to adjust the fit of the doors.
J x 1
D x 1
NOTE:
Repeat process for Right wardrobe door.
Hanging
rail x2
10

Screw (Short) Screw (Long)Washer x 2
Plastic wall plug
(For brick and masonary wall use
only).
Fabric strap
The furniture is supplied with a fixing kit which will secure it and help to guard against accidental tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place wardrobe against the wall where it is to be fitted. Mark the wall 25mm (1”) down from the top
of the wardrobe.
2. Using the 25mm screw, washer and the appropriate wall fixing attach the fabric strap to the marked
position.
3. Attach the fabric strap to the top of the wardrobe using the 15mm screw and the washer.
Before use, ensure that the strap is securely fixed to both the wall and the wardrobe.
1. 2. 3.
Assembly 16
WARNING!
IN ORDER TO PREVENT OVERTURNING, THIS PRODUCT MUST BE USED WITH THE WALL ATTACHMENT
DEVICE PROVIDED.
Serious or fatal crushing injuries can occur from furniture tipping over. To help prevent topple over,
please observe the following:
1. Use the wall attachment device provided.
2. Never allow children to climb or hang on drawers, doors or shelves.
3. Place heaviest items in the lower drawers or shelves.
4. Unless specifically designed to accommodate, do not set TV’s or other heavy objects on top of this
product.
5. Never open more than one drawer at a time.
An attachment device is provided with your product; however, you will need to source suitable fixings
for your wall type. If in doubt, please consult a qualified tradesperson.
Always ensure the wall to be drilled is free from hidden electrical wires, water and gas pipes.
Furniture stability
11

For customer care or enquiries:
Call: 01692 408802
Email: [e-mail]
East Coast Nursery Ltd. Robertson House, North Walsham,
Norfolk, NR28 0BX
eastcoastnursery.co.uk
Care and maintenance
In use
All assembly fittings should be tightened properly and should be checked regularly and re-tightened
as necessary. Take care when moving the furniture, as careless handling may cause damage.
Cleaning is simple; just wipe over with a damp cloth, and avoid using strong detergents or abrasives.
An occasional light application of a wax polish will help maintain the finish.
Be aware of the risks of open fires and other such sources of strong heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the wardrobe.
Do not use if any of the parts are broken, torn or missing.
Any additional or replacement parts can only be obtained from the manufacturer or the distributor.
Only use the wardrobe on a stable and level surface.
Ensure that the wall strap is used to securely attach the wardrobe to the wall to prevent tipping.
8584
07_17