Elite Screens Kestrel Series User manual

Rev111010-ESC
www.elitescreens.com
How to replace a Kestrel Series circuit board
1. Raise the screen about 2 feet,
and then unplug the power cord.
VERY IMPORTANT: Use rope to
tie the screen from both ends
after raising it. When removing
the end cap, the screen will
spring open and can cause
serious injury and can
permanently damage the screen.
2. REMOVE the 6 screws as
shown on the picture marked
in red.

Rev111010-ESC
www.elitescreens.com
3. Carefully remove the end
cap cover to avoid pulling out
the motor.
5. Push the cover to the side
to remove it.
4. After removing the end cap
cover, you will notice a metal
box directly behind the
screen’s material. This metal
box houses the circuit board.
Loosen and remove the
screws that hold the cover of
this metal box.

Rev111010-ESC
www.elitescreens.com
6. For easier access of the
circuit board housing, push
the power cord underneath
the screen so that it is out of
the way.
8. Detach indicated wires from
the circuit and remove the
small screws that hold it in
place. Then, remove the
circuit board. Do the reverse
of step 8 instructions to
replace the new circuit board.
7. To open the circuit board
box cover, push in on the tab
as shown in the picture and
pull the box open with both
hands simultaneously.

Rev111010-ESC
www.elitescreens.com
9. Put the circuit box cover
back in to place.
10. Place the circuit box back
in to place.
11. Use the included screw to
guide the metal cover back in
to place.

Rev111010-ESC
www.elitescreens.com
14. Be sure to turn the end
cap at a 45 degree radius
upwards when replacing it so
that the motor peg can insert
back into the cap to allow the
cap to seal back in to its place.
12. Put metal box cover back
in to place and tighten with
the screw and nut.
13. For easier access, place a
small platform (like a piece of
Styrofoam) under the screen
so that it is elevated about a
few inches. Check to be sure
that the limit switches are
facing the right direction as
shown in this picture and that
the wires are snugly put back
in to the screen’s casing so
that the end cap cover can be
easily replaced.

Rev111010-ESC
www.elitescreens.com
15. Fully extend the power
cord out of the casing before
completely sealing the end
cap back in to place.
16. Put the end cap back in to
place and tighten the end cap
with the provided screws as
shown in the picture.
17. Check for any loose wires
that may be sticking out of the
casing. The slit for the screen
should be clear for a smooth
deployment of the material.

Rev111010-ESC
www.elitescreens.com
18. If in case the end cap does
not seal properly, check to be
sure that the limit switch cap
is fully inserted in to the
roller.