Elo TouchSystems TouchSystems 0700L User manual

Quick Installation Guide
Included Items
Touch and Non-Touch Monitors
Elo TouchSystems 0700L
1 - USB cable with additional power connection
4 - screws, M4x8mm

1 5
2 6
3
4
4
3
2
1 5
6
Installation
Remove the cable cover by
pressing down on the latch and
sliding outward.
Plug the other end of the cable
labeled “DATA cable” to a USB
port on the computer.
NOTE: Some computers may
require additional power by
plugging the “Aux Power Cable”
connector into an additional USB
port.
Install the DisplayLink and touch
drivers on your computer.
Note: This monitor can not
function as primary display
during boot-up. An additional
display must be used to install
the DisplayLink driver on the
computer.
Reinstall the cable cover.
(Optional) The monitor can
be attached to any standard
75mmx75mm VESA mounting
bracket using the 4 - M4x8mm
mounting screws included with
the monitor.
Install USB cable and route
cable through the bottom of the
opening as shown.
AUX Power
Cable
DATA Cable