Emerson SolaHD STC-SLAC Series User manual

SolaHD™ STC-SLAC Series Surge Protection Devices
While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp LLC d/b/a Appleton Group
assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions.
The Emerson logo is a trademark and service mark of Emerson Electric Co.
Appleton Grp LLC d/b/a Appleton Group. SolaHD is a registered trademark of Appleton Grp LLC.
All other marks are the property of their respective owners. © 2020 Emerson Electric Co. All rights reserved.
A272-257 Rev. 4 July 2020
UNPROTECTED
(FIELD) SIDE
4/20 mA SIGNAL
UNPROTECTED
(FIELD) SIDE
120 VAC POWER
PROTECTED
(EQUIP) SIDE
4/20 mA SIGNAL
PROTECTED
(EQUIP) SIDE
120 VAC POWER
Installation
Signal Line Connections:
• Connect GND Terminal to Local Ground using #12 AWG wire minimum
• L1 and L2 – Connect for Signal Pair #1
• L3 and L4 – Connect for Signal Pair #2
• Terminals accept #24-#14 AWG wire, torque to 4kg-cm
• “S” Connection for Cable Shield ( if applicable)
CAUTION: Do not place this product in service on any signal line capable of suppying more than
150 milliamperes continuously.
AC Power Connections:
• Connect AC Power as Marked on Case using #12 AWG wire minimum
• Keep 120 VAC Power feed separate from Low Voltage 4/20 mA feed
Ordering Information
STC-SLAC-12036
• Polycarbonate case
• Includes: STC-642-036 data/signal dual-pair SPD, up to 36V rated
Technical Support
Phone: 1.800.377-4384 or 1.847.268.6651
E-mail: [e-mail]
Web site: www.solahd.com

Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
SolaHD:
SLAC32036LC SLAC02036LC