Empire Comfort Systems 41052 User manual

41101-0-0919 Page 1Empire Comfort Systems Inc. • Belleville, IL
FOR USE ON: GWT35W(NATURAL, PROPANE), HWGW350(NATURAL, PROPANE)
41052 - VENT SAFETY SWITCH RELOCATION KIT
WARNING
This conversion kit is to be installed by an Empire Comfort Systems, Inc. dealer (or other qualied
agency1)* in accordance with the manufacturer’s instructions and all codes and requirements
of the authority having jurisdiction. Failure to follow instructions could result in serious injury
or property damage. The qualied agency performing this work assumes responsibility for this
conversion.
1 National Fuel Gas Code Z223.1 (Latest Edition), Natural Gas and Propane Installation Code,
CSA B149.1
*The term “qualied agency” means any individual, rm, corporation or company which either in
person or through a representative is engaged in and is responsible for (a) the installation of gas
piping or (b) the connection, installation repair, or servicing of equipment, who is experienced
in such work, familiar with all precautions required, and has complied with all the requirements
of the authority having jurisdiction.
Tools Required:
• Phillips Screw Driver
• 1/4-Inch Nut Driver
• Drill (Optional)
• 5/16-Inch Nut Driver
• 1/8-Inch Drill Bit (Optional)
Relocation Instructions
1. Remove blower (if installed)
by lifting off 2 mounting
screws and set aside.
2. Remove 3 screws from the
top of heater and 2 screws
from the lower front.
See Figure 1.
3. Remove front casing.
INSTALLATION INSTRUCTIONS
SWITCH RELOCATION KIT
Figure 1

41101-0-0919Page 2 Empire Comfort Systems Inc. • Belleville, IL
4. Remove vent safety switch by removing (2) #8 x 1/4
inch screws. See Figure 2.
Figure 2
5. Install vent safety switch relocation bracket by sliding
it behind the existing vent safety switch bracket. See
Figure 3.
Figure 3
6. Vent safety switch bracket can be secured by two
methods: See Figure 4.
• Method # 1:
Use vent safety switch relocation bracket as a
template and drill (4) 1/8 inch holes. Use (4) #10
x 1/2 inch black sheet metal screws to attach
bracket to diverter .
• Method # 2:
Use (4) #10 x 1/2 inch self drilling screws to
attach the vent safety switch relocation bracket
to the diverter.
Figure 4
7. Attach the vent safety switch in the new location and
attach the cover in the original location with (4) #8 x 1/4
inch screws. See Figure 5.
Figure 5
8. Replace front casing.
9. Verify unit lights and burns properly.

41101-0-0919 Page 3Empire Comfort Systems Inc. • Belleville, IL
PARTS LIST
Part Discription Part Number
#10 x 1/2 inch black sheet metal screw R2737
#10 x 1/2 inch self-drilling screw R1433
#8 x 1/4 inch screw R1131
Cover 41053
Vent Safety Switch Relocation Bracket 41050

41101-0-0919Page 4
www.empirecomfort.com
Empire Comfort Systems Inc.
Belleville, IL
If you have a general question
about our products, please e-mail
us at [email protected].
If you have a service or repair
question, please contact your dealer.