Empire Comfort Systems LS40STB User manual

Page 1
INSTALLATION INSTRUCTIONS
(SEE HOMEOWNER MANUAL FOR OPERATING INSTRUCTIONS)
GAS-FIRED
INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
WARNING
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
— Do not store or use gasoline or other
ammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
•
Do not touch any electrical switch;
do not use any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
• If you cannot reach your gas
supplier, call the re department.
— Installation and service must be
performed by a qualied installer,
service agency or the gas supplier.
LOG SET
MODEL LS40STB
For Use With
DVCT40SP Fireplaces
�
WARNING
If not installed, operated and maintained
in accordance with the manufacturer’s
instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
NOTICE: Ceramic logs may differ in appearance
from those shown in this manual.

41016-1-0820Page 2
EMBER IDENTIFICATION
DVCT40
PART# FRONT TOP
40747
Ember (1) Ember (1
40748
Ember (2) Ember (2)
40749
Ember (3) Ember (3)
40750
Ember (4) Ember (4)
40751
Ember (5) Ember (5)
40752
Ember (6) Ember (6)
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.
NOTE: Embers supplied with replace.

41016-1-0820 Page 3
LOG IDENTIFICATION
DVCT40
PART# FRONT TOP
40753
Log (A) Log (A)
40754
Log (B) Log (B)
40755
Log (C) Log (C)
40756
Log (D) Log (D)
40757
Log (E) Log (E)
40758
Log (F) Log (F)
40759
Log (G) Log (G)
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.

41016-1-0820Page 4
LOG IDENTIFICATION
DVCT40
PART# FRONT TOP
40760
Log (H) Log (H)
40761
Log (I) Log (I)
40817
Log (J) Log (J)
40818
Log (K) Log (K)
40819
Log (L) Log (L)
40820
Log (M) Log (M)
40821
Log (N) Log (N)
36747
Coals (100)
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.

41016-1-0820 Page 5
NOTE: Install liners before logs. See separate Liner Installation
manual for details.
CAUTION
Do not handle these logs with your bare hands. Always
wear gloves to prevent skin irritation from ceramic bers.
After handling the logs, wash your hands gently with soap
and water to remove any trace of bers.
Accessing the Interior of the Fireplace
See Homeowners Manual for instruction on how to remove the
barrier screen and glass door.
Log Set Installation
The positioning of the logs is critical to the safe and clean
operation of this replace. Sooting and other problems may
result if the logs are not properly and rmly positioned in the
replace. Please refer to Figure 1 and the following WARNING
when completing log placement instructions. For step by step log
placement instructions, (See Pages 5 - 21).
WARNING
Failure to position the parts in accordance with this diagram
or failure to use only parts specically approved with this
replace may result in property damage or personal injury.
Burner Pin Location
Figure 1
Glowing Embers Information
1. Carefully separate the ember material into small amounts
(no larger than “dime-size” pieces).
a. Fluffed up pieces of ember material one layer thick
will produce the best ember glow. Do not place more
than one layer of ember material onto the burner.
Excess ember material will decrease the ember
glow effect.
b. Save any remaining ember material for future
applications (as needed).
Glowing Ember Location
Figure 2
Video of log installation available on our website at:
www.empirecomfort. com.
LOG AND EMBER PLACEMENT

41016-1-0820Page 6
LOG AND EMBER PLACEMENT
1. Place Ember (1) onto burner base and onto one pin as shown.
TOP
REAR
1

41016-1-0820 Page 7
LOG PLACEMENT
2. Place Ember (2) onto burner base and onto two pins as shown.
TOP
REAR
2

41016-1-0820Page 8
LOG PLACEMENT
3. Place Ember (3) onto burner base and onto two pins as shown.
TOP
REAR
3

41016-1-0820 Page 9
LOG PLACEMENT
4. Place Ember (4) onto burner base and onto two pins as shown.
TOP
FRONT
4

41016-1-0820Page 10
LOG PLACEMENT
5. Place Ember (5) onto burner base and onto two pins as shown.
TOP
FRONT
5

41016-1-0820 Page 11
LOG PLACEMENT
6. Place Ember (6) onto burner base and onto one pin as shown.
TOP
FRONT
6

41016-1-0820Page 12
LOG PLACEMENT
7. Place decorative rocks across burner base in front of the outer burner tube. Do not cover the burner tube ports.
TOP
FRONT
REAR

41016-1-0820 Page 13
LOG PLACEMENT
8. Place the Glowing Embers on the burner tubes covering all ports.
TOP
FRONT
REAR

41016-1-0820Page 14
LOG PLACEMENT
9. Place Log (A) onto two pins of Ember (B) as shown.
TOP
REAR
A

41016-1-0820 Page 15
LOG PLACEMENT
10. Place Log (B) onto two pins of Ember (B) as shown.
TOP
REAR
B

41016-1-0820Page 16
LOG PLACEMENT
11. Place Log (C) onto two pins of Ember (C) as shown.
TOP
REAR
C

41016-1-0820 Page 17
LOG PLACEMENT
12. Place Log (D) onto two pins of Embers (C) and (D) as shown.
TOP
FRONT
D

41016-1-0820Page 18
LOG PLACEMENT
13. Place Log (E) onto one pin of Ember (D) as shown.
TOP
FRONT
E

41016-1-0820 Page 19
LOG PLACEMENT
14. Place Log (F) onto one pin of Ember (E) as shown.
TOP
FRONT
F

41016-1-0820Page 20
LOG PLACEMENT
15. Place Log (G) onto one pin of Ember (D) as shown.
TOP
FRONT
G