Epoch Design NIKO 5480 User manual

Congratulations on the purchase of your Niko (Aniko) Platform Bed. This bed has been crafted to the highest
standards of quality and safety and will give you many years of enjoyment and practical use.
On this insert you will nd a list of the hardware and platform bed parts as well as detailed assembly
instructions. Assembly is quite simple and requires only a at head screwdriver and a Phillips head screwdriver. The use
of a power drill with Phillips head attachment is helpful but not necessary. Assembly will be most easily accomplished
if you take the time to carefully sort the hardware and familiarize yourself with the function of each piece.
If you need assistance with assembly, part replacement or any other matter, please contact the toll-free Epoch
Design Customer Service Team from Monday through Friday, 9 AM-6PM PST at 1 [phone]. You may also email
your request or comments to inf[email protected]om and a customer service representative will respond.
Thank you and Enjoy
EPOCH DESIGN , LLC NIKO / ANIKO PLATFORM BED
5480, 5479, 5478
28-Sept-20181/2
HARDWARE LIST
1x Slat Bundle
rest on side rails and
supports mattress
(strap side down)
2x Side Rails
Used to connect
end boards
BED PARTS
HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990
Activate your Epoch Design Limited Lifetime Warranty: www.epochbydesign.com/register
1x Headboard
1x Footboard 1x Center Support
1x Drop Support
2x Brackets
Used to attach
headboard and
footboard
39x Wood Screws
Used to attach
slat bundle to rails
12x Machine Screws
Used to attach
brackets
2x 70mm Bolts
Used to attach
drop support to
center support
4x 110mm Bolts
Used to attach
rails to headboard
1x Wrench
Used to tighten
footboard to rails
4x Half Moon Bracket,
Nut & Steel Dowel
Used to attach
footboard to rails
4x Barrel Nuts
Used to tighten
drop support
1x Allen Wrench
Used to tighten
center support bolts
mm 10 20 30 40 50 60 70 80 90 100 110

Attach the brackets to the head and foot
boards (open end up) using the machine
screws provided.
Have a question?? Need a part ASAP?? Call 1 -800-589-7990 9 AM - 5 PM PST
Insert all four of the threaded steel dowels into
the foot board by hand. Slide the footboard slat
side in toward the side rails so that the dowels go
through the holes at the end of the side rails.
Slide the half moon
washer over the
dowel as shown.
Hand tighten the nut behind the half moon washer.
Repeat this process on the other side rail, then use
the wrench provided to tighten the nuts evenly.
1Using four 110mm bolts and four barrel nuts,
attach the side rails to the headboard.
Note: Do one rail at a time and only hand tighten the bolts.
Once both sides
are threaded, fully
tighten the bolts
with the allen
wrench provided.
2
Attach the drop support to the center support by
inserting two 70mm bolts through the drop
support into the center support and tighten
with the allen wrench provided.
Lower the center support into the brackets.
3Spread the slat bundle, strap side down,
evenly across the side rails.
Secure the rst slat on one end then the nal slat on the other
end, ensuring the slats are distributed evenly.
Use the remaining wood screws to secure all the slats
to the side rails with a Phillips head screwdriver.
A power screwdriver with clutch set to low comes in
handy for this step.
4
3
1
2
4
28-Sept-20182/2