Epoch Design Nara Bamboo User manual

Nara Bamboo Platform Bed
Congratulations on the purchase of your Epoch Design Nara Bamboo Platform Bed.
This bed has been crafted to the highest standards of quality and safety and will give
you many years of enjoyment and practical use.
Since this is a natural bamboo wood product there will be variations in color and
grain, and minor wood grain checking may occur. This is normal and does not
compromise the integrity of your dresser. Variation in the character of wood is
integral to the beauty and appeal of this furniture, and distinguishes it from lower
quality materials.
On this insert you will find a list of the hardware and platform bed parts necessary for
assembly, as well as detailed instructions. Assembly is quite simple and requires only
a flat head screwdriver and a Phillips head screwdriver. The use of a power drill with a
Phillips head attachment and a clutch set on low is helpful but not necessary.
Assembly will be most easily accomplished if you take the time to carefully sort the
hardware and familiarize yourself with the function of each piece.
If you should require assistance with assembly, part replacement or any other matter,
contact the toll-free Epoch Design Service Center from anywhere in the Continental
United States, Monday through Friday, 9AM-5PM Pacific Standard Time at (800)
589-7990. You may also fax your request or comments to [phone] and/or
email to [e-mail] and a service representative will respond.
Thank you and Enjoy

STEP 1
Using 4 x 110mm bolts and 4 x barrel
nuts attach the bed rails to the head-
board as shown in Figure 1. Note: Do
one rail at a time and only hand tighten
the bolts at this time.
Figure 1
Figure 2
STEP 2
Insert all 4 of the threaded steel
dowels into the footboard by hand.
Slide the footboard toward the side
rails so that the dowels go through the
holes at the end of the side rails. Slide the
bracket over the dowel as shown. Hand
tighten the nut behind the bracket. Use the
wrench provided to tighten the nut.
Note: the narrow end of the nut should protrude
through the bracket when fully tighten.
6 x
STEP 3
Using the 12 machine screws provided, attach
the 2 steel center support brackets (open end
up) to the foot and head board as shown in
Figure 3.
Figure 3

STEP 4
Insert the center support rail into these brackets
as shown in Figure 4.
Figure 4
STEP 5
Lay out the slats evenly on bed, strap side down. Screw the slat
closest to the headboard rst against the two outside rails.
Secondly screw the slat closest to the footboard to the two
outside rails. Then do the rest in any order. Note: Do not attach
screws to the center support since this may crack the bamboo
center rail.

Nara Bamboo Platform Bed
Hardware & Parts List
Have a question? Need a part ASAP? Please call 1-800-589-7990 (9am to 5pm PST).
1 x HEADBOARD
1 x FOOTBOARD
2 x CENTER SUPPORT BRACKETS
4 x 110mm BOLTS
12 x MACHINE SCREWS
2 x SIDE RAILS
1 x CENTER SUPPORT
16 x SLATS
4 x BRACKET ASSEMBLIES
1 x WRENCH 1 x ALLEN WRENCH
32 x WOOD SCREWS 4 x BARREL NUTS