EZee Life CHRF2010 User manual

Model: CH1044
Model # Size
CHRF2010 12”
CHRF2011 16”
CHRF2012 18”
CHRF2013 24”
CHRF2014 32”
Floating flange allows for vertical,
horizontal or angled installation.
Limited Warranty:
Ezee Life™ products carry a one year warranty against
manufacturing defects, faulty materials and workmanship only.
Any alterations, misuse, abuse, or accidental damage voids this
warranty. Ezee Life™ reserves the right to replace or repair any
part that has become defective.
The warranty does not e tend to consequential costs resulting
from the fault or defect of the product: freight and travel costs,
loss of earnings, or other e penses that one may incur.
Warranty is valid for the original purchaser only and the original
receipt must be presented before any warranty options are
considered. Please also be prepared to provide the date of
purchase and serial number.
EZee Life™ Products
34 Futurity Gate, Unit 15
Concord (Ontario) L4K 1S6
Chrome Knurled Grab Bar
…...............................................

Specifications:
Wall/Bar Gap: 1½" between wall and gripping area
Bar diameter: 1”
Bar length: 12”, 16”, 18”, 24” or 32”
Installation method: Screwed to wall using rotating flange
Weight capacity: Dependent on wall & installation quality
Features:
Durable, chrome-plated steel
Easy to clean
No-slip knurled grip
Mounts vertically, horizontally or angled
1½" between wall and gripping area
Available in five lengths
Installation:
NOTE: Mounting flanges of grab bar must be aligned to mount to wall studs.
Wood screws must go through the wall board or tile and attach to wood wall
studs for solid support. For plastic tub and shower enclosures, drill through
wall and mount grab bar to wall studs.
1. Place grab bar on wall in line with wall studs and mark location of screw
holes. (Horizontal Attachment See Figure 1, Vertical Attachment See Figure
2.) After deciding on type of attachment, drill small hole to confirm the
location of the stud.
WARNING: Both wood screws in each flange must be attached to wall studs or
grab bar may pull out and serious injury could result
2. Use masonry bit to drill through tile or grout (Use caution when drilling near
edges of tile. They may chip or shatter). For wood screws, drill small pilot
hole into wood studs.
3. After holes are drilled, place grab bar on wall and attach with wood screw.
NOTE: Caulk around grab bar flanges to prevent moisture from seeping into walls.
4. Tighten all screws and bolts with screwdriver. Check periodically for tightness. Never
use grab bar if any looseness is detected as it could result in personal injury.
Figure 1 Figure