Fike FIK-RVM User manual

PN LS10311-000FK-E:A 03/04/2021 ECN: 2890
FIK-RVM
Remote Voice Module
FIKE CORPORATION
704 SW 10th Street
Blue Springs, MO 64015
www.fike.com
1 Description
The FIK-RVM Remote Voice Module is contained within the FIK-LOC or FIK-2100LOC Local Operator Console. It provides a supervised micro-
phone to be used for live communication and operates as an interface for the Emergency Communication System.
1.1 Compatibility
The FIK-RVM is compatible with the following Fike Series, Fire Alarm Control Panels (FACPs).
For information on the programming, the DIP switch settings, the addressing and the wire connections, refer to following FACP Installation Manuals.
The documents are located on the Fike Series website, www.fike.com.
1.2 Specifications
The following list the specifications.
2 Board Layout and Mounting
1. Open the cabinet door and the dead front panel.
2. Remove the AC power and disconnect the backup batteries from the Main Control Panel.
3. Mount the FIK-RVM in the middle section of the dead front on the six mounting studs. See Figure 1.1.
.
Figure 1.1 FIK-RVM Back View
NOTE: The installation and wiring of this device must be done in accordance with the NFPA 72 and the local ordinances.
• FCP-2100ECS • FCP-300ECS
Document Document Part Number
FCP-2100ECS Manual LS10143-002FK-E
FCP-300ECS Manual LS10145-002FK-E
• Standby Current: 60mA
• Alarm Current: 80mA
SBUS address
DIPs
dead front panel
mounting holes
SBUS
VBUS1
Audio
AUX
Input
AUX
Audio
Trigger
VBUS2

2FIK-RVM Product Installation Document — P/N LS10311-000FK-E:A 03/04/2021
3 Wiring to a FACP
To properly wire the FIK-RVM to the FACP SBUS, see Figure 1.2.
Figure 1.2 Wiring the FIK-RVM to the FACP
supervised
power-limited
FIK-RVM

FIK-RVM Product Installation Document — P/N LS10311-000FK-E:A 03/04/2021 3
3.1 Microphone Installation
1. Clip the microphone into the microphone clip. See Figure 1.3.
Figure 1.3 Hang Microphone into the Microphone Clip
2. Insert the microphone cord through the hole at the bottom of
the dead front panel. See Figure 1.4.
Figure 1.4 Microphone Cord Inserted Through the Dead Front
Panel Hole
3. Attach the strain relief clip to the microphone cord. The strain
relief clip should have about 2¾”(6.98cm) of the microphone
cord through it. See Figure 1.5.
4. Push the strain into the hole in the dead front panel.
5. Connect to the FIK-RVM board.
6. Restore the AC power and reconnect it to the backup batteries.
Figure 1.5 Strain Relief Clip Installation
microphone
clip
2 3/4” (6.98cm)