FireplaceXtrordinair 564 SS FPX User manual

564 SS FPX Arched Face
Upgrade Kit 98500683
Page 1 of 2 7/18/07 © Travis Industries, Inc.
Compatibility:
• 564 SS Fireplace with FPX Arched Face Packing List: • Tiling guide (2 pieces - left and right)
• (4) Mounting Brackets (attaches to the fireplace)
• (4) Screws
• (8) 8-32 Keps Nuts
This upgrade kit (98500683) must be installed prior to installing the facing material or face.
Installation
1 Attach the brackets to the fireplace following the directions below.
Remove and discard the nuts and bushings
above and below the firebox.
Place the upper and lower brackets in place
and secure using the nuts included with this
kit.
Repeat these steps for the opposite side.
Upper
Bracket
Lower
Bracket
Upper
Left
Lower
Left
Upper
Right
Lower
Right
Bracket
Identification
Discard the stock
bushings and nuts.
Discard the stock
bushings and nuts.

564 SS FPX Arched Face
Upgrade Kit 98500683
Page 2 of 2 7/18/07 © Travis Industries, Inc.
2 Attach the tiling guide following the directions below.
Slide both tiling guides into place.
NOTE: the tiling guide has slots that
slide between the brackets and the
fireplace.
Loosen the nuts on the upper
brackets three turns (both sides).
Re-tighten the nuts on the brackets
(typically you only need to tighten the
lower nuts and hand-tighten upper
nuts).
Use the four included screws to secure
the tiling guides to the fireplace frame.
a
b
c
d