FireplaceXtrordinair 4237 EG User manual

4237 EG Fireback Installation
96100879 Brick, 96100880 Herringbone, 96100875 Enamel Black,
96100882 Stacked Tan Brick
Page 1 of 3 17602212 - 8/24/21 Travis Industries, Inc.
Compatibility
4237 Fireplace EG (FIREBACKS ARE REQUIRED BEFORE OPERATING THE 4237 EG FIREPLACE)
Packing List
Rear Fireback (ceramic firebacks have 2 pieces - note orientation below)
NOTE: The rear fireback of the Herringbone and the Stacked Tan kits have an arrow cast into the back. To
ensure proper brick alignment make sure the arrow is pointing upward. The rear panel of the Handmade Brick
liner can be installed with either edge facing up.
Left and Right Side Fireback (note orientation below)
Handmade Brick Handmade Herringbone Stacked Tan Brick
Each side fireback
has a small notch
at the front of the
upper edge

4237 EG Fireback Installation
96100879 Brick, 96100880 Herringbone, 96100875 Enamel Black,
96100882 Stacked Tan Brick
Page 2 of 3 17602212 - 8/24/21 Travis Industries, Inc.
Installation
WARNING Turn off gas to the appliance and make sure it is cool prior to conducting service.
1. The firebacks should be installed while
finalizing the installation (before
installing the logs). Remove the glass
frame.
2. Remove the 8 fireback clips inside the
firebox. These clips have keyhole slots
that allow them to be removed without
removing the screws (see illustration to
the right).
Black Enamel Firebacks Only
Remove the rear log shelf. Loosen the 2 screws that secure the shelf to the unit, slide the shelf backward
slightly and lift to remove. After the rear firebacks are in place, replace the log shelf.

4237 EG Fireback Installation
96100879 Brick, 96100880 Herringbone, 96100875 Enamel Black,
96100882 Stacked Tan Brick
Page 3 of 3 17602212 - 8/24/21 Travis Industries, Inc.
3. Ceramic Firebacks:
Place the lower rear fireback in place. While
holding it in place, place the upper, rear
fireback on top of it (continue to hold both in
place).
Enamel Black Firebacks:
Place the rear fireback in place.
The enamel fireback has a 1-piece rear
fireback
All Firebacks:
Replace the side fireback clips, followed by the
upper fireback clips to secure the rear
fireback(s).
4 Place one side fireback in place.
Secure with the two fireback clips.
Repeat these steps for the
remaining side fireback.
5 Restore the fireplace to the correct configuration (see manual for details).
CLEANING ENAMEL FIREBACKS
We recommend cleaning the enamel surface with glass cleaner and a soft cloth.