FireplaceXtrordinair 96100838 User manual

864 Fireback Installation
sku# 96100838 – 96100839 - 96100840 – 96100841 – 96100842
Page 1 of 3 17602072 - 3/21/19 Travis Industries, Inc.
Compatibility
864TRV 31K Std.
864TRV 31K CF

864TV 40K Std.
864TV 40K CF
For 864 fireplaces built prior to those listed above (2019), floor firebacks may be needed to complete the
installation. Contact Travis Industries for details.
Packing List
Rear Fireback
(2) Side Firebacks
Tools Needed
1/4” Nut driver
5/16” Nut driver
Installation
The firebacks are fragile (especially the rear fireback). Take care when handling the firebacks.
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 Remove the glass frame and logs (see the installation manual for details).
2 Remove the media tray skirt and rear
air deflector.






a
b
1/4" Nutdriver

864 Fireback Installation
sku# 96100838 – 96100839 - 96100840 – 96100841 – 96100842
Page 2 of 3 17602072 - 3/21/19 Travis Industries, Inc.
3 Remove and
discard the
media tray cover
plates.
4 Remove the
exhaust
restrictor from
the firebox
ceiling.












Back Wall of Firebox
Firebox Roof
NOTE: These obround holes allow
for the restrictor to be removed
with the screws still in place.
Loosen these 4 screws on
the exhaust restrictor.
Ledgestone Firebacks Only
The tabs on the media tray must be bent out – see below. You will need to remove the media tray (2 screws hold
it in place) to bend the tabs out.
Bend these tabs
outwards (both sides).
The side and back
firebacks rest on top
of these tabs.

864 Fireback Installation
sku# 96100838 – 96100839 - 96100840 – 96100841 – 96100842
Page 3 of 3 17602072 - 3/21/19 Travis Industries, Inc.
5 Install the firebacks as shown below.







b






c
5/16" Nutdriver
a
Remove the clips on both sides
(these clips have key-holes,
allowing removal without removing
the screw) Place the rear fireback in position.
The side fireback holds the rear
fireback in place – support the rear
fireback while installing the side
fireback.
Place the side
firebacks in position.
Secure using the
screws and clips
removed in step “a”
6 Restore the fireplace to the correct configuration.