First Data FD400 User manual

31
FD400 Terminal
Quick Set-Up Guide
FD400
04/24/2009 6:00PM
Swipe Card
or Select Transaction
Credit Debit EBT
Gift Check Loyalty

23
Thanks for choosing the
First Data™ FD400 Terminal.
The FD400 is an easy-to-use terminal
that goes with you wherever your
business takes you. Installation is quick
and easy. With an integrated PIN pad
and thermal printer, you will be able to
process payments on the go. Simply
follow the instructions and begin
accepting electronic payments today.
What’s in the box?
• FD400 Terminal
• 2.25” Thermal Paper Roll
• Lithium-Ion Battery (7.4V, 2.2 A)
• Two-piece AC Power Supply
• Privacy Shield
3
AC Input
The AC input port is found on the left side of the terminal (under
the plastic cover). To connect your power adapter to the FD400 lift
the plastic cover and insert the connector into the AC port.
Note: The mini-USB connector above the AC power input port is not
for merchant use.
There are two holes under a plastic cover on the left side
of terminal.
Getting to know the
FD400 Terminal

354
Let’s get started...
Typical set-up time: 5-10 minutes
Where to put the FD400 Terminal
The FD400 terminal is designed to be used as a handheld device.
When placing it on a desk or tabletop, please avoid areas with
direct sunlight, objects that radiate heat, excessive dust and other
electrical devices that can cause excessive voltage.
Note: In order to meet the FCC RF exposure guidelines for body-
worn operation, this terminal should be kept at least 20 cm from
the body.
A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference with nearby
radio and television reception. It is essential that only the supplied
power cord be used.
Plug in the power to charge
the battery
Install the battery into the terminal, then connect the power cord
to the power supply via the three-prong end receiver to charge
the battery. Once the battery is fully charged, the FD400 can run
on battery power for several hours before requiring a new charge.
Find the power button on the front of the terminal.
Caution: Risk of explosion if the battery is replaced by an incorrect
type. Please dispose of used battery according to the instructions.
Note: Make sure the battery is installed in the terminal before
connecting to the power supply to charge.
FD400
04/24/2009 6:00PM
Swipe Card
or Select Transaction
Credit Debit EBT
Gift Check Loyalty
Power Button

Privacy Shield Installation
The privacy shield allows customers to input their information in
a safe and secure environment. Simply place the privacy shield
around the perimeter of the 16-key keypad. When the privacy
shield is installed, the keypad is separated into two parts; the
numeric keys are protected within the shield.
Note: If the FD400 is used without the detachable privacy shield,
additional criteria must be met in order to comply with the PCI
privacy screen design requirements.

MIS-CSI-FDQSGDE
© 2009 First Data Corporation. All Rights Reserved
“Federal Communications Commission (FCC)Statement”
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.