Fisher-Price 71207 Guide

Replacement Kit Parts
Get-Up & Go Walker
Front Panel Replacement Kit
Instruction Sheet
IMPORTANT! Enclosed is a new front panel for your walker.
Please follow these instructions carefully.
Replacement Instructions
Get-Up & Go Walker
Front Panel Replacement Kit
Model Number: 71207
IMPORTANT! Enclosed is a new front panel for your walker.
Please follow these instructions carefully.
NewFront Panel
InstructionSheet
Replacement Kit Parts
Model Number: 71207
Replacement Instructions
WARNING
• Your child could be injured upon contact with the front panel of the walker.
• Do not use the walker until you replace the front panel.
• Your child could be injured upon contact with the front panel of the walker.
• Do not use the walker until you replace the front panel.
WARNING!
Tool required for front panel assembly:
Phillips screwdriver (not included).
Tool requiredforfrontpanel assembly:
Phillipsscrewdriver(not included).
New Front Panel
Part Not Shown: Label Sheet
Part Not Shown: Label Sheet
71207pr-0922.qrk 10/24/0 5:41 PM Page 1

Replacement Instructions
Proper label application will help to keep the
labels looking their best!
• Make sure the areas where the labels will
be applied are clean and dry. Wipe all
parts with a clean, dry cloth to remove
dust or oils. Avoid re-applying a label.
• Apply the labels, as shown, to the new front
panel.
Helpful Hint: Align the notches in labels 3
and 6 with the key lines on the front panel.
New Front Panel - Outside
2
4
3
1
• Loosen the screws in the old front panel with
a Phillips screwdriver. Remove the screws
and keep them for Step 4.
• Remove the side panels from the front panel.
• Safely throw away the old front panel.
Old Front Panel
Side Panels
Screws
Screws
Tab
Wheel
Side Panel
Side Panels
New
Front
Panel
Front Panel
• Position the new front panel on a flat surface.
• With the wheels on the side panels facing
out, fit the tabs on the side panels into the
slots in the front panel. Make sure the wheel
on each side panel faces out.
Helpful Hint: You may want to use an
electric screwdriver with a Phillips head bit.
36
45
• While holding a side panel firmly against the
front panel, insert two #6 x 1 1/4" screws
through the holes in the front panel and into
the side panel.Tighten the screws with a
Phillips screwdriver until the top of each
screw is flush with the surface of the
front panel. Do not over-tighten. Repeat this
procedure to fasten the front panel to the
other side panel.
Front panel replacement is now complete.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2000 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
New Front Panel - Inside
Printed in U.S.A. 71207pr-0922
If you have further questions regarding the
installation of the new front panel, please call
Fisher-Price®Consumer Relations, toll free at
1-800-233-4004, 8 AM - 6 PM EST Monday
through Friday. Hearing-impaired consumers
using TTY/TTD equipment, please call
1-800-382-7470. Or, write to: Fisher-Price®
Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
71207pr-0922.qrk 10/24/0 5:41 PM Page 2