Fisher-Price B0322 User manual

w
w
w.
fi
s
he
r
-p
r
i
c
e
.
c
o
m
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” (LR6) alkaline batteries (not included).
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips screwdriver (not included)
IMPORTANT! An adult should convert this toy from:
activity center to walker or walker to activity center.
B0322
Instructions
Musical Activity Walker™

2
Battery Installation
Battery Compartment Door
Battery Safety Information
Batteries may leak fluids that can
cause a chemical burn injury or ruin
your toy. To avoid battery leakage:
•Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or recharge-
able (nickel-cadmium).
•Insert batteries as indicated inside
the battery compartment.
•Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the toy.
Dispose of batteries safely. Do not
dispose of batteries in a fire. The
batteries may explode or leak.
•Never short-circuit the battery
terminals.
•Use only batteries of the same or
equivalent type as recommended.
•Do not charge non-rechargeable
batteries.
•Remove rechargeable batteries
from the toy before charging.
•If removeable, rechargeable
batteries are used, they are only to
be charged under adult supervision.
SHOWN ACTUAL SIZE
1.5V x 3
“AA” (LR6)
•Locate the battery compartment
door on the bottom of the toy.
•Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the
battery compartment door.
•Insert three "AA" (LR6) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline
batteries for longer life.
•Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.
•When sounds from this toy become
faint or stop, it’s time for an adult to
change the batteries!

3
Label Application
1
2
3
4
6
8
5
(Under 6)
13
14
15
7
(Under 8)
10 9
(Under 10)
12
11
(Under 12)
Proper label application will help to keep the labels looking their best.
•Wash your hands before applying the labels.
•Make sure the areas where the labels will be applied are clean and dry. Wipe
this product with a clean, soft, dry cloth to remove any dust or oils.
•For best results, do not attempt to apply a label more than once.
•Apply the labels as shown in the illustration.

4
Walker - Upright Position
Hint: The Musical Activity Walker is
ready to use as an activity center in the
folded position. Follow the instructions
below to convert the Musical Activity
Walker from an activity center - folded
position to the walker - upright position.
To prevent pinching or
crushing, always lock the
product in its upright position
or in its folded position.
WARNING
Handle
Rear
Leg
Rear
Wheel
Base
Arrows
To lock in the
upright position:
•Position a rear leg over the arrow
on the base, near the rear wheel.
•Push the rear leg down and slide it
toward the rear wheel until you hear
a “click”.
•Pull up on the rear leg to be sure it
is secure.
•Repeat this procedure to attach the
other rear leg to the base.
IMPORTANT! To avoid pinching, be
sure your fingers are not near the
arrows on the base when locking
the rear legs into position.
•While holding one of the rear wheels,
lift the handle.
Hint: This may require some force.
1
2
Center Ball
When baby pushes the walker or spins the
center ball (in upright position only), lively
music plays!
•Locate the power/volume switch on
back of the toy.
•Slide the switch to
the desired position:
Off O;on with low
volume ; or on with
high volume .
Center Ball
Sounds and Music - Upright Position

•While holding one of the rear wheels,
push the handle down toward the rear
wheels until it “snaps” into place.
IMPORTANT! Make sure this product
is locked into position by securely
“snapping” into place.
Handle
Activity Center - Folded Position
3
To lock in the
folded position:
Rear
Leg
•While pressing the arrow, carefully
slide the rear leg slightly toward the
front wheel.
IMPORTANT! Be careful to move your
fingers from the arrow after you have
unlocked the leg to avoid pinching.
•Repeat this procedure to unlock the
rear leg on the other side of the toy.
2
•Position the Activity Walker so that
the side is facing you.
•To unlock the rear leg, press the
arrow near the rear wheel, as shown.
Rear
Wheel
Press Arrow
1
5
Hint: Follow the instructions below to convert the Musical Activity Walker from a
walker to an activity center - folded position.

Wipe this toy with a clean cloth dampened with a mild soap and water solution.
Care
Consumer Information
Questions? We'd like to hear from you!
Call Fisher-Price ®Consumer Relations, toll-free at
1-800-432-5437, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment, please call
1-800-382-7470. Or, write to: Fisher-Price®Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-567-7724, Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.Helpline: 01628 500302.
AUSTRALIA:Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND:16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA:Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
PRINTED IN MEXICO B0322b-0920
©2004 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement (United States Only)