Fisher-Price BOUNCE & SPIN ZEBRA K0317 User manual

K0317
Please keep this instruction sheet
for future reference, as it contains
important information.
Requires three “AAA” (LR03) alkaline
batteries (not included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
This product is intended for use indoors
on carpeted surfaces.
For children ages 12-36 months who
are able to get on and off unassisted.
Weight limit: 43 lbs. (19.05 kg).
www.fisher-price.com
Bounce &
Spin ZebraTM

#8 x 7 /8” (2.2 cm) Screw - 10
Shown Actual Size
Note: Tighten or loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
6 Feet
CapHandlebar
6 Base Pieces
Zebra
This product contains small parts in its
unassembled state. Adult assembly is required.
Take extra care during unpacking and assembly.
CAUTION
Parts

Foot
• Fit the cap into the center of the post.
Cap
Base Piece
• Insert six screws into the cap and tighten.
• Turn the assembly upright.
• Fit and “snap” each base piece between the spaces in the feet.
Hint: The base pieces are designed to be asssembled to any of
the openings between the feet, and is a one-time assembly.
Post
• Position the zebra upside-down.
• Fit the tube end of a foot into one of the holes inside the post.
• Assemble the other five feet into the post.
Assembly
1
2
3
4

• While sliding the ends of the handlebar into the indents on each
side of the zebra’s head, fit the post into the slot in the top of the
zebra’s head.
Handlebar
• Insert four screws into the handlebar and tighten.
• Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this
toy apart.
• Check the plastic parts regularly and if broken or cracked,
dispose of them properly.
Post
Assembly
Consumer Information
Care
5
6

• Locate the battery compartment on the back of the handlebar.
• Loosen the screws in the battery compartment door. Remove the
battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries, as indicated inside
the battery compartment.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screws.
• If this toy begins to operate erratically, you may need to reset the
electronics. Slide the power/volume switch off and then back on.
• When lights or sounds from this toy become faint or stop, it’s
time for an adult to change the batteries!
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of product in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
• Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
(United States Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Battery Safety Information
Battery Installation FCC Statement
1.5V x 3
“AAA" (LR03)
ICES-003
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement aux conditions
suivantes: (1) il ne doit pas produire de brouillage et (2) l’utilisateur
du dispositif doit être prêt à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
NMB-003
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this device
may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause
undesired operation.

Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. K0317f-0920
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
• Place this toy on a flat surface.
• Slide the power/volume switch to either on with low volume or on with high volume .
• Bounce and spin while sitting on the seat. Spin the roller on the handlebar for lights and music!
• When you are finished playing, slide the power/volume switch off .
Power/Volume
Switch
Lively Music, Sounds, Lights and Activities Too!