Fisher-Price Chatter Telephone HGJ69 User manual

1
Chaer Telephone™
HGJ69 Owner’s Manual

2
Give your childhood a call.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Fisher-Price is under license.
Other trademarks and trade names are those of their respective owners.
©2021 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted.
PRINTED IN CHINA HGJ69-0970-DOM

3
Parts
Rotary Dial
Hands-Free Buon
“Wiggly” Eyes
Handset Cable
Rolling Wheels
USB Charger Input
USB Charging
Cable
Handset
3

4
Charging
1. To charge, turn the phone around and locate the USB port.
2. Connect the included micro USB cable to the phone’s USB port.
3. Plug the opposite end of the micro USB cable into a powered computer’s USB port or
connect to a 5V/1000mAH USB charger (not included) and plug into an outlet. A red LED
will light up on the USB port to indicate that the battery is charging.
4. The red LED will go off when the battery is fully charged (approx. 4 hours).
5. Disconnect the micro USB cable.
Note: A 5V/1000 mAH USB charger is not included with Chatter Telephone™and must
be purchased separately. This type of charger is universal and can be purchased at any
major retailer.

5
Setup
1. Locate the red power
button on the underside
of the phone.
2. Press and hold the
power button for
approx. 3 seconds
until a blue LED light
turns on and the phone
says, “Hi there!” Press
and hold again for 3
seconds to turn the
phone off, and it will
say, “Love you, bye!”
3. Open the Settings
menu on your device
and turn on Bluetooth.
4. Select “Chatter
Telephone” on the
Bluetooth® device list.
You will hear the phone
say “Good to go”
when the devices are
successfully paired.
Hint: If you cannot pair
your device with the
phone, try moving the
device closer to
the phone.

6
Placing and Receiving Calls
1. Place your finger in the opening of the number that you would like to dial and rotate
clockwise until you reach the finger stop.
2. Allow the dial to return to its original position before dialing the next number. (You should
hear the phone say each digit as you are dialing the numbers.)
3. After you finish dialing, wait for approx. 5 seconds for your call to connect.

7
Placing and Receiving Calls
Speakerphone
Receiving calls is as easy
as picking up the handset
when the phone rings!
You can adjust the
speaker volume of the
Chatter Telephone™ by
adjusting the volume on
the Bluetooth® device that
it is paired with.
Press the red button at
any time during a call
to enter speakerphone.
You can then return the
handset to the phone
cradle. To return to
handset mode, pick up
the handset and continue
your call.
If pressed when the phone
rings, it will answer in
speakerphone. Press
again to end the call.

8
Ready to Roll?
Work can be play with the
Chatter Telephone™! Take
a break with a childhood
friend with these rolling
wheels and “wiggly” eyes.
Or if you want the phone
to stay put, slide the
latch on the underside to
lock the wheels in place.
Simply slide the latch
back when you want to
roll again!

9
Handset Cable
A 4 pole 3.5 mm audio cable is included with Chatter Telephone™ for use of the handset.
The handset cable is segmented for safety reasons. If the cable becomes disconnected at
any time, simply reconnect it to return function to the handset.
If the handset cable is lost or damaged, a new one can be purchased separately at any
major retailer.

10
Consumer Information
Compatible with all Bluetooth®-enabled devices.
Approximately 9 hours of talk time.
Approximately 72 hours of stand by time on a full battery charge.
Approximately 15 ft. Bluetooth® range.
Recharges via micro USB cable (included).
If lost or damaged, a new micro USB cable charger can be purchased separately at any
major retailer.
Reset If the phone begins to
operate erradically, you
may need to reset the
electronics. Press the
main reset button with the
point of a pen (or similar
object).