Fisher-Price H8589 User manual

H8589
www.fisher-price.com/uk
Please keep this instruction sheet
for future reference, as it contains
important information.
Maximum weight:
19 kg. (42 lbs).
For ages between
9 months and
3 years.
Requires three “AA”
batteries (included).
Adult assembly is required.
Tool required for
battery replacement:
Phillips screwdriver
(not included).
Walk n Drive
Learning Car

2
Base
2 Caster Wheels
Front Wheels
Dashboard
Parts
3 Shape Sorter Blocks
Hood
Note: A plastic tab is attached to the toy for in-store demonstration
purposes. While the tab may have already been removed,
check the dashboard to be sure. If the plastic tab is still attached,
pull and remove the tab from the toy. Throw the plastic tab away.
CAUTION
Please keep small parts such as plastic tabs out
of children’s reach. Throw the plastic tab away.
Before Use
Not Shown: Label Sheet

• Place the base upside down on a flat surface.
• “Snap” the front wheels to the underside of the base,
as shown.
Assembly
Bottom View
• Fit the peg on the left side of the hood into the matching
hole in the dashboard.
• Press to “snap” the other peg into the dashboard.
Front Wheels
• Insert and “snap” the caster wheels into the base,
as shown.
Hint: This may require some force.
• Pull up on the caster wheels to be sure they are secure to
the base.Turn the base over.
Caster Wheels
• Insert and “snap” the dashboard into the base,
as shown.
Hint: This may require some force.
• Pull up on the dashboard to be sure it is secure to the base.
Dashboard
Hood
3
1
2
3
4

For best performance, we
recommend replacing the
batteries that came with
this toy with three, new
alkaline “AA” (LR6) batteries.
• Locate the battery compart-
ment on the dashboard.
• Loosen the screws in the
battery compartment door
with a Phillips screwdriver.
Remove the battery
compartment door.
• Insert three "AA" (LR6) alkaline batteries, as indicated inside
the battery compartment.
Hint: We recommend using alkaline batteries for longer life.
• Replace the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.
• When lights or sounds from this toy become faint or stop,
it’s time for an adult to change the batteries!
In exceptional circumstances, batteries may leak fluids
that can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of the product in
a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under adult supervision.
4
1,5V x 3
“AA” (LR6)
SHOWN ACTUAL SIZE
Battery Replacement Battery Safety Information
4
53
12
3
Battery Compartment Door
Battery Replacement
Proper label application will help to keep the labels looking
their best!
• Wash your hands before applying the labels.
• Make sure the areas where the labels will be applied are
clean and dry. Wipe your vehicle with a clean, soft, dry cloth
to remove any dust or oils.
• For best results, avoid applying a label more than once.
• Apply the labels as shown in the illustration above.

Latch
Bottom View
Bottom View
Slide
1
2
• Turn the toy over. Press and slide
the latch to an open position,
as shown.
5
• Spread the seat halves until they
“click” in place. Turn the toy over.
It is now ready to be used as a walker.
To change to Walker mode, follow these steps:
Walker
1
2