Fisher-Price I Can Play Bowling User manual

N0461
N0461
www.fisher-price.com
www.fisher-price.com
N0461
www.fisher-price.com

Assembled Parts
5 Pins
2 Bumpers
Base
Storage
• Snap the ball in place behind the pins.
• Close the bumpers.
Care
• This product may be wiped clean using a mild cleaning solution and
a damp cloth. Do not use bleach. Do not use harsh or abrasive
cleaners. Rinse clean with water to remove residue.
• Periodically inspect this product for wear and damage and replace
any cracked parts.
Consumer Information
Label Sheet
• Please keep this instruction sheet for future reference, as it contains
important information.
• Adult assembly is required. No tools required for assembly.

Assembly
• Position the number 4 pin next to the number 2 pin and the number
5 pin next to the number 3 pin.
• While making sure the tabs on the number 4 and 5 pins are behind
the number 2 and 3 pins, attach the pins using the same procedure
in assembly step 2.
4
3
• Position the number 2 pin and the number 3 pin next to the number
1 pin.
• While making sure the tabs on the number 2 and 3 pins are behind
the number 1 pin, attach the pins using the same procedure in
assembly step 2.
Number
2 Pin
Number 3 Pin
Slots
Number 4 Pin Number 5 Pin
Slots
Slots
2
• At an angle, insert the longer peg on the number 1 pin into the
groove at the front and center of the base.
• Push down on the other side of the pin to "snap" it in place.
Number 1 Pin
Grooves Base
• "Snap" the bumpers into the holes on the sides of the base.
Hint: If a bumper does not seem to fit on one side of the base, try
assembling it to the other side of the base!
5
Bumper
Bumper
1
• Carefully peel a label from the label sheet and attach it to a pin,
as shown.
• Smooth out the label to remove any air bubbles.
• Repeat this procedure to apply the remaining labels to the remaining
bowling pins.
Tabs Behind Pin
Tabs Behind Pins

Set ‘em Up and Knock ‘em Down!
PRINTED IN CHINA N0461pr-0920
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
• Open the bumpers on the sides of the base. • Slide the tab on the bumper to keep score!
3
• Push the lever behind the right bumper to set the pins
up again.
Hint: The pins are designed to breakaway from the base.
Simply re-attach them using the procedure in assembly
step 2.
4
1
• Roll the ball towards the pins.
2