Fisher-Price Color Me Gemz Belt Set N1128 User manual

N1128
N1128
IMPORTANT! The ink in Color Me Gemz™ pens is
intended to be permanent and will stain fabrics,
carpet, clothing, walls and furniture. Cover all work
surfaces BEFORE coloring the gem sliders and buckles.
Adult supervision is recommended.
• To remove markings from skin, use soap
and water.
• For best results, use only the Color Me Gemz™
pens to decorate the buckles and sliders.
• The belt is surface wash only. Wipe with a clean,
damp cloth.
• Replace the caps on Color Me Gemz™ pens after
each use.
Please keep this instruction sheet for future reference,
Please keep this instruction sheet for future reference,
as it contains important information.
as it contains important information.
CHOKING HAZARD – Small Parts
Not suitable for children
under 3 years.
WARNING
PRINTED IN CHINA N1128pr-0920
PRINTED IN CHINA N1128pr-0920
Fisher-Price, Inc., a subsidiary of Mattel, Inc.,
Fisher-Price, Inc., a subsidiary of Mattel, Inc.,
East Aurora, New York 14052, U.S.A.
East Aurora, New York 14052, U.S.A.
©2008 Mattel, Inc. All Rights Reserved. ® and ™
©2008 Mattel, Inc. All Rights Reserved. ® and ™
designate U.S. trademarks of Mattel, Inc.
designate U.S. trademarks of Mattel, Inc.
• Place newspaper or another protective material
on your work surface.
2 Color Me Gemz™ Pens
Woven Belt
2 Interchangeable
Gem Buckles
2 Gem Belt Sliders
All manuals and user guides at all-guides.com
all-guides.com

6. When finished, be sure to
replace the cap on each
Color Me Gemz™ pen.
3. Wrap the belt around your waist.
Fit the end of the belt through the
slot in the buckle base. Lower the
top of the buckle to fasten the
belt in place.
4. Fit the pegs on the back of a
buckle into the wider end of
each slot in the buckle base.
1. Use the tip of the Color Me Gemz™
pen to color the facets on a gem slider
or buckle. For best results, only color
the faceted areas on each gem.
5. Turn the buckle to lock in place! If
you’d like to remove the buckle,
simply turn and lift the buckle
from the base.
2. Fit the end of the belt through the
slot on the back of each slider.
All manuals and user guides at all-guides.com