Fisher-Price Little Superstar L4805 User manual

www.fisher-price.com
L4805
Please keep this instruction sheet
for future reference, as it contains
important information.
Requires three “AA” batteries (included).
Adult assembly is required.
Tool required for assembly: Phillips
screwdriver (not included).

Parts
This product contains small parts for assembly by an adult.
Take extra care during unpacking and assembly.
2
Base
Microphone
Microphone Holder
#6 x 1" Screw – 6
Shown Actual Size
2 Front Legs
Note: Tighten and loosen all screws with
a Phillips screwdriver. Do not over-tighten.
2 Rear Legs
CAUTION

Assembly
• Position the base so that the bottom
is upright.
• Fit both front legs to the bottom of the
base, as shown.
• Insert two screws into the front legs
and tighten.
3
Base
Front Legs
Rear Legs
• Fit both rear legs to the front legs,
as shown.
• Insert four screws into the rear legs
and tighten.
• Set the assembly upright.
• “Snap” the microphone holder to the
side of the assembly.
Microphone
Microphone
Holder
• Set the microphone into the micro-
phone holder.
1
2
3
4

Battery Replacement
4
For best performance, we recommend
replacing the batteries that came with
this toy with three, new alkaline “AA”
(LR6) batteries.
• Locate the battery compartment on the
back of the toy.
• Loosen the screw in the battery compartment
door
and lift to remove it.
• Insert three, new “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door
and tighten the screw.
• When lights or sounds become faint or stop,
it’s time for an adult to change the batteries!
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of batteries
safely. Do not dispose of the product in
a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
toy before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
1.5V x 3
"AA" (LR6)

5
Sing Along Fun!
Volume Switch
Song
Select
Button
Mode Switch
Sing Along Fun – Press any button or shake the microphone to start the music.
Press the guitar, keyboard, drum or horn to hear a solo by that instrument.
Build an Instrumental Song
1.
Shake the microphone for fun phrases or "scatting."
2. Press any button to start the music.
3. Press the guitar, keyboard, drum or horn to add that instrument to the song.
Press again to take that instrument out of the "mix."
Hint: The microphone only activates sounds when the music stops.
Off – Slide the switch when you are finished playing with this toy.
Volume Switch
Slide the switch to low volume or high volume .
Song Select Button
Press to change to another song.
Hint: Rattle sounds from other objects or toys may activate music and lights.
Mode Switch

United States Only
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible
for compliance could void the user's authority
to operate the equipment.
FCC Statement
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. L4805a-0920
Care
Wipe with a clean cloth dampened with
a mild soap and water solution. Do
not immerse. This toy has no consumer
serviceable parts. Do not take this toy apart.
Consumer Information