Fisher-Price Fun 2 Learn J6870 User manual

1
J6870
www.fisher-price.com

2 Legs
#8 x 3/4"(1.9 cm)
Washerhead Screw – 10
#8 x 3/4"(1.9 cm)Screw – 10
#6 x 1/2"(1.3 cm)Screw – 4
All Shown Actual Size
Note: Tighten and loosen all screws with a Phillips
screwdriver. Do not over-tighten.
Desktop
Shelf
2 Retainers
Clock
2 Storage Bins
Keyboard
2 Feet
Consumer Information
• Please keep this instruction sheet for future reference, as it
contains important information.
• Requires three ”C” (LR14) alkaline batteries (not included).
• Adult assembly is required.
• Tool needed for assembly: Phillips screwdriver (not included).
Parts
Fasteners
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. J6870a-0920
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN MEXICO
2
2
2

Battery Installation
3
3
Battery Safety Information
Note: We recommend using alkaline batteries for longer
battery life.
• Locate the battery compartment on the underside of
the keyboard.
• Loosen the screws in the battery compartment door. Remove
the battery compartment door.
• Insert three “C” (LR14) alkaline batteries.
• Replace the battery compartment door and tighten the screws.
• When sounds or lights from this toy become faint or stop, it's
time for an adult to change the batteries!
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product. To
avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as
recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
1.5V x 3
"C" (LR14)
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities
(Europe only).
• Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this
toy apart.
Care
(United States Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
FCC Statement

Shelf
Slots
Keyboard
Legs
• Place the keyboard face down on a flat surface.
• Fit the legs into the keyboard.
Hint: The legs are designed to fit one way.
• Insert three #8 x 3/4” (1.9 cm) washerhead screws into each leg
and tighten.
• Position the shelf.
• Fit the ends of the shelf into the slot in each leg.
• Fit a foot onto each leg.
Hint: The feet are designed to fit one way.
• Insert three #8 x 3/4” (1.9 cm) screws into each foot and tighten.
Feet
Assembly
4
4
1
2
• Insert two #8 x 3/4” (1.9 cm) washerhead screws into each end
of the shelf and tighten.
3
4

5
• Fit a storage bin to the grooves on each side of the keyboard.
Hint: The storage bins are designed to fit one way.
• Insert two #8 x 3/4” (1.9 cm) screws into each storage bin
and tighten.
Storage Bin
Storage Bin
• Turn the assembly upright.
• “Snap” the clock into the slots in the top side of the assembly.
Clock
Desktop
Pegs
• Fit the pegs on the desktop into the slots in the top side of
the assembly.
Retainer
Retainer
• Fit a retainer over each desktop peg.
• Insert two #6 x 1/2” (1.3 cm) screws into each retainer
and tighten.
• Lift and lower the desktop.
Assembly
7
6
8
5
5

Decoration
6
2
5
4
3
6
1

Lift and lower the desktop to learn upper and lower case letters, numbers, shapes and how to draw.
Turn the clock hands for
fun music and lights.
Slide the power/volume
switch to either on with
low volume ; on with
high volume ; or off .
Numbers
Press to learn numbers and how
to write them.
Shapes
Press to learn shapes and how to
draw them.
Drawing
Press to learn how to draw objects.
The display screen shows how.
Uppercase Letters
Press to learn words that begin with
the letter chosen and how to write
that letter.
Lowercase Letters
Press to learn words that begin
with the letter chosen and how
to write that letter.
It’s Fun to Learn!
7
7
Use the arrow buttons to
scroll through letters, numbers,
objects and shapes. Press the
select button to choose it.

Raise the desktop for musical fun and activities.
Lets Make Some Music!
8
8
Keep the Beat
When the “drums” light up, tap
them before the lights go out.
Instrument Select
Press to choose an instrument:
piano, guitar, trumpet or flute.
Press the keys on the keyboard to
hear the sound of the instrument
chosen. You can also choose silly
sound effects or animal sounds.
Songs and Dancing
Press to hear different
“get-up-and-move”
songs along with
dancing lights! Play-
along on the keyboard
or the “drums.”