Fisher-Price R9698 User manual

www.fisher-price.com
R9698
R9698
Please keep these instructions for future reference,
Please keep these instructions for future reference,
as they contain important information.
as they contain important information.
Requires three “AAA” batteries (included) for operation.
Requires three “AAA” batteries (included) for operation.
Adult assembly is required.
Adult assembly is required.
Tool required for battery replacement: Phillips screwdriver (not included).
Tool required for battery replacement: Phillips screwdriver (not included).

Battery
Replacement
For best performance, we recommend
replacing the batteries that came with
this toy with three, new “AAA” (LR03)
alkaline batteries.
• Locate the battery compartment on the
bottom of the drill.
• Loosen the screw in the battery compart-
ment door and remove the door.
• Remove the exhausted batteries and
throw them away.
• Insert three, new “AAA” (LR03)
alkaline batteries.
Hint: We recommend alkaline batteries
for longer battery life.
• Replace the battery compartment door
and tighten the screw.
• If this product begins to operate
erratically, you may need to reset the
electronics. Remove the batteries
and replace them.
• When sounds become faint/stop or
movement becomes slow/stops, it’s time
for an adult to change the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Safety
Information
Assembly
• Fit the handle into the toolbox, as shown.
• Push to "snap" the handle in place. Pull
up on the handle to be sure it's secure.
1.5V x 3
"AAA" (LR03)

Interchangeable
Drill Bits
Real Drillin' Action!
• Pull the drill bit out of the end of the drill.
Hint: To replace the drill bit, simply insert
into the socket in the drill.
• Store the drill bit in the tool caddy.
• Insert and snap the other drill bit into
the end of the drill.
• Slide the switch on top of the drill for
forward and reverse drilling action!
• Press and hold the trigger to drill
the screws into the holes in the toolbox.
Hint: If the drill stops while you are using
it, release the trigger and then squeeze
it again.
Drill Bit
Forward
and Reverse
Switch

FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference and
(2) this device must accept any
interference received, including interference
that may cause undesired operation.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA R9698a-0920
Consumer Information
ICES-003
• This Class B digital apparatus complies
with Canadian ICES-003.
• Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes:
(1) il ne doit pas produire de brouillage
et (2) l’utilisateur du dispositif doit
être prêt à accepter tout brouillage
radioélectrique reçu, meme si ce brouillage
est susceptible de compromettre le
fonctionnement du dispositif.
Care
• Wipe this toy with a clean cloth
dampened with a mild soap and water
solution. Do not immerse this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.